Turner Construction Senior Project Engineer Civil Interview Questions and Answers

Response Surface Methodology (RSM) is a statistical technique used to model and analyze the relationship between a response variable and multiple input variables.

• Design a set of experiments based on a factorial design

• Collect data from the experiments

• Fit a regression model to the data

• Analyze the model to determine optimal input settings for the response variable

Bus bar schemes are different ways of connecting bus bars in power systems.

• Single bus bar scheme

• Double bus bar scheme

• Main and transfer bus bar scheme

• Ring bus bar scheme

• Breaker and a half scheme

• Mesh bus bar scheme

The equipment sequence for any line bay starts with the circuit breaker and ends with the transformer.

• The circuit breaker is the first equipment in the sequence.

• Next comes the isolator switch.

• After that, the earth switch is operated.

• Then the line disconnector is opened.

• Finally, the transformer is disconnected from the line.

• The sequence is reversed when the line bay is put back into service.

Pile heads are removed to allow for further construction or to ensure proper load transfer to the foundation.

• To prepare for further construction on top of the piles

• To ensure proper load transfer to the foundation

• To facilitate the installation of pile caps or beams

• To adjust the pile length if necessary

There are four deductions of 90 degree angles.

• A 90 degree angle is formed when two lines intersect at a right angle.

• In a square, all four angles are 90 degrees.

• In a rectangle, opposite angles are 90 degrees.

• In a right triangle, one angle is always 90 degrees.

Static load test is used to measure the load capacity of a structure under a constant load, while dynamic load test is used to measure the response of a structure to varying loads.

• Static load test involves applying a constant load to a structure and measuring its response over time.

• Dynamic load test involves applying varying loads to a structure to simulate real-life conditions.

• Static load test helps determine the maxi...read more

The number of tolerance of pile load test depends on the specific project requirements and standards.

• The number of tolerance of pile load test can vary based on the project specifications and standards.

• Typically, a tolerance of +/- 5% to +/- 10% is considered acceptable for pile load tests.

• Some projects may have more stringent tolerance requirements depending on the criticality of the structure.

• It is important to refer...read more

Bentonite has a range density of 17-22 lb/gal and is used in civil engineering for drilling fluid, grouting, and sealing purposes.

• Range density of bentonite is typically between 17-22 lb/gal.

• Bentonite is used in civil engineering for various purposes such as drilling fluid, grouting, and sealing.

• The range density of bentonite is important for determining its effectiveness in different applications.

• Higher range density ...read more