Filter interviews by
I applied via campus placement at National Institute of Technology (NIT), Silchar and was interviewed in Jan 2023. There were 4 interview rounds.
Apptitude+technical test easy questions basics only
TCE interview questions for designations
Top trending discussions
posted on 9 Mar 2024
The number of bricks needed in 1m3 depends on the size of the bricks being used.
The number of bricks in 1m3 will vary based on the size of the bricks. Standard brick size is 190mm x 90mm x 90mm.
For standard size bricks, approximately 500 bricks are needed in 1m3.
To calculate the number of bricks needed, divide the volume of 1m3 by the volume of one brick.
Fos is a type of admixture used in concrete to improve its workability and durability.
Fos is a water-reducing admixture that helps in reducing the water content in concrete mixtures.
It improves the workability of concrete, making it easier to place and finish.
Fos also enhances the durability of concrete by reducing permeability and increasing strength.
Examples of Fos for concrete include polycarboxylate-based admixture
posted on 19 Dec 2023
I applied via Job Portal and was interviewed in Jun 2023. There were 2 interview rounds.
True power is the actual power consumed by a device, while reactive power is the power required to establish and maintain the electromagnetic fields in an AC circuit.
True power is measured in watts (W) and represents the actual energy consumed by a device.
Reactive power is measured in volt-amperes reactive (VAR) and represents the power required to establish and maintain the electromagnetic fields in an AC circuit.
True...
posted on 29 Jul 2022
I applied via campus placement at Meghnad Saha Institute of Technology, Kolkata and was interviewed in Aug 2022. There were 2 interview rounds.
The candidate is asked to draw the BMD & SFD of a Simply Supported Beam shown on the screen.
Identify the support conditions of the beam (simply supported in this case)
Determine the loads acting on the beam and their positions
Calculate the reactions at the supports
Draw the Bending Moment Diagram (BMD) and Shear Force Diagram (SFD) based on the calculated values
Label the diagrams with appropriate values and units
Compressive shear stress is zero while tensile shear stress is equal to the shear force divided by the cross-sectional area of the beam.
Compressive shear stress is zero in a singly reinforced beam according to the Limit State Method (LSM).
Tensile shear stress is calculated by dividing the shear force by the cross-sectional area of the beam.
For example, if the shear force acting on the beam is 10 kN and the cross-sectio...
posted on 25 Nov 2022
Civil engineering questions based on basics concepts , some aptitude and english questions ,grammer test
posted on 8 Aug 2020
I applied via campus placement at Vellore Institute of Technology (VIT) and was interviewed before Aug 2019. There were 4 interview rounds.
posted on 11 Oct 2015
I applied via Walk-in
based on 3 interviews
Interview experience
based on 6 reviews
Rating in categories
Assistant Manager
478
salaries
| ₹4.5 L/yr - ₹12.8 L/yr |
Manager
354
salaries
| ₹6.1 L/yr - ₹16.1 L/yr |
Senior Engineer
321
salaries
| ₹3.6 L/yr - ₹10 L/yr |
Senior Manager
285
salaries
| ₹10 L/yr - ₹22.5 L/yr |
Consultant
256
salaries
| ₹4 L/yr - ₹13 L/yr |
Infosys
Wipro
HCLTech
Tech Mahindra