Aker Solutions Civil Structural Designer Interview Questions and Answers

The bolt to bolt distance depends on the specific design requirements and standards for the structural connection.

• The bolt to bolt distance is typically specified in the design drawings or calculations provided by the engineer.

• It is important to follow the recommended bolt to bolt distance to ensure the structural integrity of the connection.

• The bolt to bolt distance may vary depending on factors such as the size and t...read more

Edge distance refers to the distance between the edge of a structural member and the center of a hole or fastener.

• Edge distance is typically specified in design codes and standards.

• It is important to maintain adequate edge distance to prevent failure of the connection.

• The required edge distance can vary depending on the type of connection and the loading conditions.

• For example, in steel connections, the minimum edge di...read more

The type of weld used for connecting a column to a base plate is typically a fillet weld.

• Fillet welds are commonly used for connecting structural steel components.

• The size of the fillet weld is determined based on the forces and stresses the connection will experience.

• Proper welding procedures and inspections are essential to ensure the weld's quality and strength.

Column to beam joints are typically connected using various methods such as welding, bolting, or using mechanical connectors.

• Common methods for connecting column to beam include welding, bolting, or using mechanical connectors

• Welding is a common method where the column and beam are fused together using heat

• Bolting involves using bolts to secure the column and beam together

• Mechanical connectors such as shear connectors ...read more

The top moment column to beam top side is typically welded on the compression side of the beam.

• Weld the top moment connection on the compression side of the beam for maximum strength.

• Ensure proper welding techniques and inspections are followed to maintain structural integrity.

• Consider using fillet welds or groove welds depending on the design requirements.

• Consult structural engineering codes and standards for specific...read more

Edge distance of 75mm is required to cover vertical reinforcement in all types of foundations.

• Edge distance is important to ensure proper anchorage and structural integrity of the reinforcement.

• In this case, a minimum edge distance of 75mm is specified for covering vertical reinforcement in all types of foundations.

• Examples of foundations where this requirement applies include spread footings, pile caps, and mat founda