i
TÜV SÜD
Filter interviews by
Clear (1)
Leaping length is the distance between two consecutive supports of a bridge or a beam.
Leaping length is also known as span length.
It is an important factor in the design of bridges and beams.
The leaping length determines the maximum load that the structure can bear.
For example, a bridge with a leaping length of 50 meters can bear heavier loads than a bridge with a leaping length of 30 meters.
UTM stands for Universal Transverse Mercator, a coordinate system used to locate positions on the Earth's surface.
UTM divides the Earth into 60 zones, each 6 degrees of longitude wide.
It uses a grid system to give a unique location to every point on the Earth's surface.
UTM coordinates are given in meters, making it easy to measure distances and areas.
It is commonly used in mapping, surveying, and navigation application...
The 20 in M20 refers to the compressive strength of concrete in megapascals after 28 days of curing.
M20 is a mix of concrete with a compressive strength of 20 MPa after 28 days of curing.
The compressive strength of concrete is the maximum load it can bear before crushing.
The strength of concrete depends on the ratio of cement, sand, and aggregate used in the mix.
Other grades of concrete include M10, M15, M25, M30, etc....
Rate your
company
🤫 100% anonymous
How was your last interview experience?
Top trending discussions
I applied via Referral and was interviewed in Aug 2021. There were 3 interview rounds.
I applied via Indeed and was interviewed in Feb 2024. There was 1 interview round.
I applied via Naukri.com and was interviewed in Jul 2022. There were 2 interview rounds.
I applied via Approached by Company and was interviewed in Aug 2022. There were 2 interview rounds.
I applied via Naukri.com and was interviewed in Dec 2022. There were 3 interview rounds.
I applied via Recruitment Consulltant and was interviewed before Mar 2022. There were 3 interview rounds.
Data required for fire & safety
Building layout and floor plans
Location of fire exits and emergency equipment
Fire suppression systems and equipment
Fire alarm and detection systems
Emergency response plan and procedures
Fittings used during charging depend on the type of refrigerant and system design.
The type of refrigerant and system design determine the fittings used during charging.
Common fittings include flare, sweat, and quick-connect fittings.
Flare fittings are commonly used in air conditioning systems.
Sweat fittings are commonly used in refrigeration systems.
Quick-connect fittings are commonly used in automotive air conditionin...
The depth required for IGL gas laying depends on various factors such as soil type, traffic load, and depth of other utilities.
The depth should be sufficient to prevent damage from external factors such as traffic load and soil type.
The depth should also be deep enough to avoid interference with other utilities.
The depth requirement may vary depending on the location and local regulations.
For example, in Delhi, the min...
based on 1 review
Rating in categories
Inspection Engineer
204
salaries
| ₹0 L/yr - ₹0 L/yr |
Assistant Manager
106
salaries
| ₹0 L/yr - ₹0 L/yr |
Lead Auditor
89
salaries
| ₹0 L/yr - ₹0 L/yr |
Field Engineer
86
salaries
| ₹0 L/yr - ₹0 L/yr |
Senior Analyst
82
salaries
| ₹0 L/yr - ₹0 L/yr |
Bureau Veritas
DNV GL
Intertek
SGS