Turbotech Engineering Design Engineer Interview Questions and Answers

Q1. Engineering Basics
Add your answer

Q1. Technical questions related to the previous experience
Add your answer

Q1. I was selected for autocad plant 3d designer. Basic pump related questions were asked. Was asked to draw pump suction and discharge piping with its components.
Ans. Tool test involved basic drafting activity.
Answered Anonymously
Add your answer

Was asked for drafting support

Q1. About current experience and special purpose machine design
Add your answer

Q1. Make a hydraulic circuit.
Ans. 
A hydraulic circuit is a system that uses liquid to transmit power.
• Identify the components needed: pump, reservoir, valves, actuators, and hoses

• Connect the components in a closed loop system

• Ensure proper sizing and placement of components for efficient operation
Answered by AI
Add your answer

60 marks
30 marks aptitude
30 marks mechanical mainly kinematics

Topic related to life without mobile

Q1. Related to our curriculum project , welding and casting.
Add your answer

Q1. Tell me about yourself Family background Hobbies
Add your answer

Q1. Engine basic questions
Add your answer
Q2. Flywheel used in a engine
Ans. 
A flywheel is a mechanical device used in engines to store rotational energy and smooth out fluctuations in engine speed.
• Flywheels are typically made of steel or aluminum and are attached to the engine's crankshaft.

• They store energy during the power stroke and release it during the compression stroke to keep the engine running smoothly.

• Flywheels are also used in hybrid vehicles to store energy from regenerative braking...read more
Answered by AI
Add your answer
Q3. Used of flywheel, crankcase, AVM pre filter
Ans. 
Flywheel, crankcase, and AVM pre filter are components used in internal combustion engines.
• Flywheel stores rotational energy and helps maintain engine speed during power strokes.

• Crankcase houses the crankshaft and other engine components.

• AVM pre filter is used to remove larger particles from the air before it enters the engine.

• These components are essential for the proper functioning of internal combustion engines.
Answered by AI
Add your answer

Q1. How to change the connector in inline wiring harness.
Ans. 
To change the connector in an inline wiring harness, follow these steps:
• Identify the type of connector needed for the replacement

• Disconnect the existing connector from the wiring harness

• Cut off the old connector, leaving enough wire length for the new connector

• Strip the insulation from the wire ends

• Crimp or solder the wires to the new connector

• Secure the new connector to the wiring harness

• Test the connection for proper
Answered by AI
View 1 more answer
Q2. How to Draw the connection line.
Ans. 
To draw a connection line, start by identifying the two points you want to connect. Then, use a ruler or straight edge to draw a straight line between the two points.
• Identify the two points you want to connect

• Use a ruler or straight edge to draw a straight line between the two points

• Ensure the line is clear and well-defined
Answered by AI
View 1 more answer

Q1. As per experience what have you done
Add your answer

Q1. Genral questions of professional experience
Add your answer