Tenon Facility Management Electrical Supervisor Interview Questions and Answers

Q1. Tell me about yourself.
View 1 more answer
Q2. What are your salary expectations?
Add your answer

Group discussion

Coding test

Q1. Chillers and hvac
Ans. 
Chillers and ahu use in comrhical buldling
Answered Anonymously
Add your answer
Q2. Chillers safety and trobulshooting the chillers ,pressure testing , deyhighdruction for chillers
Ans. 
lp hp switch , anit frzeer switch ,Lp,hp trandsuer , flow flow switch, sensor errr. under voltage alarm , high viltage alarm, low amp alarm, comp high temp etc. pressure hold 180PSI. micron 500hurnaderd is required for gas chagre ,...
Answered Anonymously
Add your answer
Q3. Ahu ,fcu , coolong tower , pump , vav
Ans. 
airhandling unit , fan coil unit . ahu . coil fan filer , motor , water criculation in coil blower air supply through duct in room FCU insatailltion in the room justblike water cool unit with blower , cooling tower use chiller dischagre temp condcation , ser pump perimary pump use in chiler and ahu
Answered Anonymously
Add your answer

Q1. Centrifugal and screw chiller service
Add your answer

Q1. Chiller service
Add your answer

Q1. How many Experience your work
Ans. 
I have 5 years of experience working as a Site Supervisor in construction projects.
• 5 years of experience as a Site Supervisor

• Managed multiple construction projects simultaneously

• Ensured adherence to safety regulations and project timelines

• Coordinated with subcontractors and communicated with clients

• Implemented cost-saving measures without compromising quality
Answered by AI
Add your answer
Q2. You Interest Change your company
Add your answer
Q3. Do you change your change
Ans. 
Yes, I am always open to change and adapt to new situations in order to improve efficiency and effectiveness.
• I believe in continuous improvement and am willing to change my approach if it leads to better results

• I am open to feedback and suggestions from team members and stakeholders

• I have successfully implemented new processes and procedures in the past to enhance productivity
Answered by AI
Add your answer
Q4. Sarary Expectations
Add your answer
Q5. Ok sir call again
Add your answer

What type of work termite tretment.

Q1. New work and new site visit.
Add your answer
Q2. What type work ?
Add your answer
Q3. How to work termite treatment ?
Ans. 
For Pre Construction Anti Termite Treatment. The surface of the ground should be dry and clean. The chemical should be injected three times in a certain order into the ground. Firstly, the earth’s surface shall be drilled in 12mm diameter and 300mm deep at 150mm intervals below the PPC. Post construction. plinth area dril in home 45 degree angel 10" hole and gave 8/10" distance & wood area .
Answered Anonymously
Add your answer
Q4. How to control mosqutio ?
Ans. 
Spray continues inside the room. Drain area spray for anti larva treatment. Garden and out site for big fogger.
Answered Anonymously
Add your answer
Q5. How to control bedbugs etc...
Ans. 
Wash bedding, clothes, and blankets in hot water . and one chemical ( propoxure20%) best work for bed bugs and cockroach and household insecticide.
Answered Anonymously
Add your answer

Q1. Maintenance engineer
Add your answer
Q2. Facility management, inventory, MMR, DSR, DMR
Add your answer

Q1. Only facility maintenance
Add your answer
Q2. Electrical, plumbing, HVAC, civil
Add your answer