Sona Comstar Production Engineer Interview Questions, Process, and Tips

I want to join JTEKT because of their reputation for innovation and commitment to excellence in the production engineering field.

• JTEKT has a strong reputation for innovation and cutting-edge technology in the production engineering industry.

• I am impressed by JTEKT's commitment to excellence and continuous improvement in their products and processes.

• I believe that working at JTEKT will provide me with valuable opportuni...read more

7 QC is a set of quality control tools used in manufacturing to identify and solve production problems.

• 7 QC stands for Seven Quality Control tools

• These tools include Pareto analysis, cause-and-effect diagram, check sheet, control chart, histogram, scatter diagram, and flowchart

• They are used to analyze data, identify root causes of problems, and make informed decisions for process improvement

PPL stands for Production Per Labour and PPLH stands for Production Per Labour Hour.

• PPL is a measure of how much production is achieved per unit of labor input.

• PPLH is a measure of how much production is achieved per labor hour.

• Both metrics are used to evaluate the efficiency of production processes.

• For example, if a factory produces 100 units with 10 workers, the PPL would be 10 units per worker.

• If the same factory op...read more

The project involved designing and implementing a new production process to improve efficiency and reduce costs.

• Identify areas for improvement in current production process

• Research and analyze different production methods and technologies

• Design and implement new production process

• Test and optimize the new process for efficiency and cost-effectiveness

Overcoming is the act of successfully dealing with or overcoming a challenge, obstacle, or difficulty.

• Identifying the challenge or obstacle

• Developing a plan or strategy to address it

• Taking action to implement the plan

• Persisting through setbacks or failures

• Learning from the experience to improve future outcomes

Five is a numerical value representing the quantity of five items.

• Five is the third prime number.

• There are five fingers on a human hand.

• A pentagon has five sides.

• A standard dice has five dots on one side.

Five S is a mnemonic used in the oil and gas industry to remember the key steps in drilling a well.

• Safety - prioritize safety measures to prevent accidents

• Survey - conduct a survey to determine the best location for drilling

• Spud - begin drilling the well

• Set casing - install casing to stabilize the wellbore

• Squeeze - perform cement squeeze to seal off any leaks