MSP Steel & Power Interview Questions, Process, and Tips

Q1. What are the mode of heat transfer ?
Ans. 
Modes of heat transfer include conduction, convection, and radiation.
• Conduction: Heat transfer through direct contact between particles. Example: Touching a hot pan.

• Convection: Heat transfer through the movement of fluids (liquids or gases). Example: Boiling water.

• Radiation: Heat transfer through electromagnetic waves. Example: Feeling the warmth of the sun.
Answered by AI
Add your answer
Q2. What is addendum Circle?
Ans. 
An addendum circle is a circle that is tangent to two other circles and intersects them at their points of tangency.
• Addendum circle is commonly used in gear design to determine the correct size of gears.

• It is tangent to two other circles, known as the base circles, and intersects them at their points of tangency.

• The addendum circle is larger in diameter than the base circles, allowing for the teeth of the gears to mesh
Answered by AI
Add your answer
Q3. Explain Rankin cycle
Ans. 
Rankine cycle is a thermodynamic cycle used in steam power plants to generate electricity.
• Rankine cycle involves four processes: compression, heating, expansion, and cooling.

• Steam is compressed in a pump, heated in a boiler to high temperature and pressure, expanded in a turbine, and then cooled in a condenser.

• The cycle is used in steam power plants to convert thermal energy into mechanical work, which is then used to
Answered by AI
Add your answer

Q1. What are the mode of heat transfer?
Ans. 
The modes of heat transfer are conduction, convection, and radiation.
• Conduction: Heat transfer through direct contact between particles. Example: Touching a hot stove.

• Convection: Heat transfer through the movement of fluids (liquids or gases). Example: Boiling water.

• Radiation: Heat transfer through electromagnetic waves. Example: Feeling the warmth of the sun.
Answered by AI
Add your answer
Q2. What is addendum circle ?
Ans. 
An addendum circle is a circle that is tangent to two other circles and intersects a third circle.
• An addendum circle is used in gear design to create a smooth transition between gears.

• It is also used in mechanical engineering for designing mechanisms with gears.

• The addendum circle is tangent to the base circle of the gear and intersects the pitch circle.
Answered by AI
Add your answer

Q1. About yourself and previous work and projecta
Add your answer
Q2. Introduce yourself
Add your answer

Written test was taken

Q1. Core engineering questions with MCQ
Add your answer
Q2. Material properties
Ans. 
Material properties refer to the characteristics and behavior of materials under specific conditions.
• Material properties include mechanical, thermal, electrical, and chemical properties.

• Examples of material properties are strength, hardness, conductivity, and reactivity.

• Understanding material properties is crucial for selecting the right materials for engineering applications.
Answered by AI
Add your answer

Q1. Final interview round done as technical round.
Add your answer

Q1. What is Six sigma in lean manufacturing
Ans. 
Six Sigma is a methodology used in lean manufacturing to improve processes by reducing defects and variation.
• Six Sigma aims to achieve a level of quality where there are only 3.4 defects per million opportunities.

• It focuses on identifying and eliminating causes of defects to improve overall process efficiency.

• Six Sigma uses statistical tools and techniques to measure and analyze process performance.

• It involves defining...read more
Answered by AI
Add your answer
Q2. What is TPM and JH and its step
Ans. 
TPM stands for Total Productive Maintenance and JH stands for Just in Time. TPM focuses on maintaining equipment to prevent breakdowns, while JH focuses on minimizing waste and improving efficiency.
• TPM involves proactive maintenance to prevent breakdowns and improve overall equipment effectiveness

• JH focuses on reducing waste, improving efficiency, and delivering products just in time to meet customer demand

• TPM steps in...read more
Answered by AI
Add your answer