L&T Construction TIG Welder Interview Questions and Answers

A transformer is an electrical device that transfers electrical energy between two or more circuits through electromagnetic induction.

• Transformers are used to increase or decrease the voltage of an alternating current (AC) power supply.

• They consist of two coils of wire, called the primary and secondary, wrapped around a magnetic core.

• When an AC current flows through the primary coil, it creates a magnetic field that in...read more

Earthing is the process of connecting electrical equipment to the earth to prevent electric shock.

• There are several types of earthing, including plate earthing, rod earthing, pipe earthing, and strip earthing.

• Plate earthing involves burying a copper plate in the earth and connecting it to the electrical equipment.

• Rod earthing involves driving a copper rod into the earth and connecting it to the electrical equipment.

• Pip...read more

Circuit breakers are of different types such as thermal, magnetic, hydraulic-magnetic, and residual current devices.

• Thermal circuit breakers use a bimetallic strip to trip the breaker when it gets too hot.

• Magnetic circuit breakers use an electromagnet to trip the breaker when it detects an overload.

• Hydraulic-magnetic circuit breakers combine the features of both thermal and magnetic circuit breakers.

• Residual current de...read more

Star delta starter is an electrical motor starting mechanism that reduces the starting current and torque.

• Used for starting high power motors

• Consists of three contactors and a timer

• Initially starts the motor in star configuration and then switches to delta configuration

• Reduces starting current and torque

• Commonly used in industrial applications

Buchholz relay is a protective device used in oil-filled transformers to detect and prevent faults.

• It is a type of gas actuated relay

• It is installed in the oil-filled transformer tank

• It detects the presence of gas or air bubbles in the oil

• It trips the transformer if a fault is detected

• It helps to prevent major damage to the transformer

MPLS is a protocol used for efficient packet forwarding. It uses labels to identify paths instead of IP addresses.

• MPLS stands for Multiprotocol Label Switching

• Labels are assigned to packets at the ingress router

• Labels are used to identify the path a packet should take through the network

• Labels are swapped at each MPLS router along the path

• The last MPLS router removes the label and forwards the packet based on the IP ad...read more

Route reflector is a BGP feature that allows a router to advertise routes to its clients without requiring full mesh connectivity.

• Route reflector reduces the number of iBGP peerings required in a network.

• It helps in scaling the network by reducing the number of updates and processing required.

• Route reflector can be configured in a hierarchical manner to further reduce the number of iBGP peerings.

• It is commonly used in ...read more

I have experience in designing and analyzing transmission lines for power distribution.

• Designed and analyzed transmission lines for power distribution projects

• Performed load flow analysis and short circuit analysis for transmission lines

• Experience in using software tools like PLS-CADD and PLS-POLE

• Knowledge of industry standards and regulations for transmission line design

• Collaborated with cross-functional teams to ensu

Design of foundation is crucial for the stability and safety of any structure.

• The type of foundation depends on the soil type and load-bearing capacity.

• Factors like building height, weight, and seismic activity must be considered.

• Proper drainage and waterproofing must be incorporated.

• Foundation design must comply with local building codes and regulations.

• Examples of foundation types include shallow, deep, and pile foun

The neutral axis is the line where the stress is zero in a reinforced concrete structure.

• The neutral axis divides the cross-section of the structure into two parts: the compression zone and the tension zone.

• The depth of the neutral axis depends on the moment of resistance of the section and the bending moment applied.

• The position of the neutral axis affects the amount of reinforcement required in the tension zone.

• The n...read more