General Motors Technical Centre India Robotic Simulation Engineer Interview Questions and Answers

I joined the company because of its innovative projects and collaborative work environment.

• Opportunity to work on cutting-edge projects

• Collaborative work environment

• Company's reputation in the industry

• Career growth opportunities

Static analysis deals with loads that do not change over time, while dynamic analysis considers loads that vary with time.

• Static analysis is used to determine the effects of loads that do not change over time, such as dead loads and live loads.

• Dynamic analysis considers loads that vary with time, such as wind loads, seismic loads, and vibrations.

• Static analysis is simpler and less computationally intensive compared to ...read more

Spectral fatigue analysis is performed by calculating the stress response of a structure to dynamic loads over a range of frequencies.

• Determine the dynamic loads acting on the structure

• Calculate the stress response of the structure using spectral methods

• Analyze the stress response at different frequencies to assess fatigue damage

• Consider factors such as material properties, load history, and environmental conditions

• Use...read more

I prioritize transparency, disclose the conflict, and recuse myself if necessary.

• Prioritize transparency and disclose the conflict to all parties involved

• Evaluate the situation and determine if recusal is necessary

• Seek guidance from a supervisor or ethics committee if unsure how to proceed

My notice period is currently one month.

• Notice period is one month

• I am required to give one month notice before leaving my current position

• I can start a new position after one month

Yes, I have extensive experience with basements and below ground structures.

• I have designed and analyzed numerous basements for residential and commercial buildings.

• I am familiar with waterproofing techniques and soil mechanics related to below ground structures.

• I have experience with retaining walls, foundations, and underground parking structures.

• I have worked on projects involving deep excavations and shoring system...read more

Orifice std refers to standard orifice sizes used in engineering. Types of taps include flange taps, corner taps, and D and D/2 taps.

• Orifice std refers to standard sizes of orifices used in flow measurement

• Types of taps include flange taps, corner taps, and D and D/2 taps

• Flange taps are used for large pipes, corner taps for small pipes, and D and D/2 taps for general applications

Pressure gauge operating range refers to the minimum and maximum pressure values that the gauge can accurately measure.

• Pressure gauge operating range is typically specified by the manufacturer.

• It is important to ensure that the pressure being measured falls within the gauge's operating range to ensure accurate readings.

• For example, a pressure gauge with an operating range of 0-100 psi should not be used to measure pres

Straight length requirements for orifice flow element ensure accurate measurement by allowing flow to stabilize before reaching the element.

• Straight length requirements typically range from 10 to 44 pipe diameters upstream and 5 to 22 pipe diameters downstream of the orifice.

• These requirements help prevent flow disturbances and ensure accurate measurement of flow rate.

• For example, if the pipe diameter is 4 inches, the ...read more

Pipe wall thickness can be calculated using various methods based on the material, pressure, and temperature of the pipe.

• Calculate using Barlow's formula: t = PD/(2S - 0.8P)

• Consider factors like material properties, pressure, temperature, and safety factor

• Consult relevant codes and standards for specific calculations

• Use software tools like CAESAR II for complex piping systems