AECOM Site Engineer Interview Questions and Answers for Experienced

Q1. Tell me about yourself.
Add your answer
Q2. Asked me my work experience and my education.
Add your answer

Q1. About My work experince and my education and my knowledge.
Add your answer

Q1. About my work experience and my education and my knowledge.
Add your answer
Q2. My Interoduction and my
Add your answer

Q1. Salary discussion and skills realted question.
Add your answer
Q2. 24/7 and rotate any across in india
Add your answer
Q3. Finally provided offer latter.
Add your answer

Q1. Structural site questions
Add your answer
Q2. Fhinishing questions
Add your answer

Q1. I accepted your job
Add your answer
Q2. Steel calculation
Add your answer

Q1. Shuttering calculation
Add your answer

Cement test, bitumen test, road density, ravite, autocad

Concrete properties grade

Q1. Initial and final setting time for cement.
Ans. 
Initial setting time is the time taken for the cement to harden to a certain degree, while final setting time is the time taken for the cement to completely harden.
• Initial setting time is typically around 30 minutes to 1 hour after adding water to the cement.

• Final setting time is usually around 2 to 4 hours after adding water to the cement.

• Setting time can vary based on the type of cement and environmental conditions.

• S
Answered by AI
View 1 more answer
Q2. What is bleeding?
Ans. 
Bleeding is the process of air escaping from fresh concrete mix and rising to the surface.
• Bleeding occurs when water in the concrete mix rises to the surface due to settlement of solid particles.

• It can lead to surface defects if not properly managed.

• Bleeding can be reduced by using proper mix design and techniques like vibration or adding admixtures.

• Excessive bleeding can weaken the surface of the concrete.

• Examples: Wa...read more
Answered by AI
Add your answer

Q1. Primavera, cost control
Add your answer
Q2. About Employee engagement, training
Add your answer

Q1. Levels of P6, Float, Critical activities
Ans. 
P6 is a project management software used for scheduling, Float is the amount of time an activity can be delayed without delaying the project, Critical activities are tasks that must be completed on time to prevent project delays.
• P6 is a software used for project scheduling and management

• Float is the amount of time an activity can be delayed without affecting the project deadline

• Critical activities are tasks that have z...read more
Answered by AI
Add your answer