Varindera Constructions Assistant Manager - QA & QC Interview Questions and Answers for Experienced

CBR stands for Code Based Routing, a method used in software development for routing messages based on code logic.

• CBR is a technique used in software development to route messages based on code logic

• It involves writing code to determine how messages should be routed

• CBR is commonly used in systems where routing decisions are complex and need to be dynamic

IS 2720 Part 8 is a standard for determining the water content of soil by oven drying method.

• IS 2720 Part 8 is a standard method used in geotechnical engineering to determine the water content of soil samples.

• The method involves weighing a soil sample, drying it in an oven, and then re-weighing to calculate the water content.

• The water content is calculated as the difference in weight before and after drying, divided by...read more

The maximum on BOCW & site situation refers to the highest number of workers allowed on a construction site based on safety regulations.

• BOCW stands for Building and Other Construction Workers, regulations set limits on the number of workers allowed on site

• Site situation includes factors like space, hazards, and emergency evacuation plans

• Maximum number of workers should be determined based on safety assessments and comp

Ohm's law states that the current through a conductor between two points is directly proportional to the voltage across the two points.

• Ohm's law is represented by the equation I = V/R, where I is the current, V is the voltage, and R is the resistance.

• It is named after Georg Simon Ohm, a German physicist who first formulated this law.

• This law is applicable to all types of circuits, including DC and AC circuits.

• It is use...read more

CT stands for Current Transformer and PT stands for Potential Transformer. They are used in electrical systems for measurement and protection purposes.

• CT is used to measure current in high voltage circuits by stepping down the current to a safe level for measurement.

• PT is used to measure voltage in high voltage circuits by stepping down the voltage to a safe level for measurement.

• Both CT and PT are essential components...read more

DTC structure stands for Direct Torque Control structure, a control method used in AC motor drives for precise torque and speed control.

• DTC structure is a control technique used in AC motor drives to directly control torque and flux without the need for a separate speed controller.

• It is based on the principle of controlling the torque and flux by selecting the appropriate voltage vectors in the motor.

• DTC structure offe...read more

LA, AB switch is used in electrical engineering to switch between two different signal sources or destinations.

• LA, AB switch is commonly used in audio and video equipment to switch between different inputs or outputs.

• It allows for easy switching between two different signal sources or destinations without having to physically disconnect and reconnect cables.

• The switch typically has two positions - one for each signal s...read more