i
Sterlite Power
Filter interviews by
The question is asking about three different things related to construction: sag chart, slump value, and C to Q.
Sag chart is a graph that shows the relationship between the flow rate and the viscosity of a material.
Slump value is a measure of the consistency of concrete or other materials.
C to Q refers to the ratio of the compressive strength to the tensile strength of concrete.
Top trending discussions
posted on 17 Feb 2022
I applied via Walk-in
posted on 28 Apr 2022
Boiler and BOP equipment are crucial components of power plants that generate electricity.
Boiler is responsible for generating steam by burning fuel, which is then used to turn turbines and generate electricity.
BOP (Balance of Plant) equipment includes pumps, fans, and other auxiliary systems that support the operation of the boiler and turbines.
BOP equipment also includes systems for water treatment, ash handling, and...
posted on 10 Jul 2022
I applied via Referral and was interviewed before Jul 2021. There were 2 interview rounds.
SPD is used in street lights to protect them from voltage surges and lightning strikes.
SPD stands for Surge Protection Device.
It is installed in the street light circuit to protect it from voltage surges and lightning strikes.
SPD diverts the excess voltage to the ground, preventing damage to the street light.
It is important to use SPD in street lights as they are exposed to outdoor elements and are prone to voltage sur...
There are three main types of solar modules: monocrystalline, polycrystalline, and thin-film.
Monocrystalline solar modules are made from a single crystal of silicon and are the most efficient and expensive.
Polycrystalline solar modules are made from multiple crystals of silicon and are less efficient but more affordable than monocrystalline.
Thin-film solar modules are made from a thin layer of photovoltaic material and...
posted on 3 Oct 2021
I applied via Naukri.com and was interviewed in Apr 2021. There were 6 interview rounds.
Tensioning is the process of applying tension to a fastener or material, while torquing is the process of applying torque or rotational force.
Tensioning involves stretching or pulling a material to create tension, while torquing involves applying rotational force to tighten or loosen a fastener.
Tensioning is commonly used in applications such as tightening cables, belts, or chains, while torquing is used in fastening b...
posted on 15 May 2018
I applied via Referral and was interviewed in Nov 2017. There were 2 interview rounds.
Assistant Manager
173
salaries
| ₹4.7 L/yr - ₹14.7 L/yr |
Chief Manager
160
salaries
| ₹10 L/yr - ₹37 L/yr |
Manager
112
salaries
| ₹7 L/yr - ₹24 L/yr |
Safety Officer
62
salaries
| ₹3 L/yr - ₹6.8 L/yr |
Quality Engineer
43
salaries
| ₹2 L/yr - ₹7.5 L/yr |
Power Grid Corporation of India
Adani Transmission
Tata Power
NHPC