Services & Trade Co. LLC Planning Engineer Interview Questions and Answers

Q1. What are you doing at your past company
Add your answer
Q2. Salary how much you want😊
Add your answer
Q3. Why you want to join our company
Add your answer
Q4. Are you dedicated with your work
Add your answer
Q5. Are you technically sound
Add your answer

Q1. Questions will be asked on previous company roles and responsibilities.
Add your answer
Q2. Depends upon previous experience.
Add your answer

Q1. Basics on structure and finishings
Add your answer
Q2. Questions on structure and finishings
Add your answer

Q1. What was your previous salary what is your expect
Ans. 
I am unable to provide my previous salary as it is confidential. However, I am expecting a competitive salary based on my qualifications and experience.
• My previous salary is confidential and I am unable to disclose it.

• I am expecting a salary that is commensurate with my qualifications and experience.

• I am open to discussing salary expectations during the negotiation process.

• I believe that a competitive salary is importa...read more
Answered by AI
Add your answer
Q2. Previous salary 1 expected salary 2 whatever.
Add your answer
Q3. Educational mass card certificate documents previous salary certificate if you worked
Add your answer

Q1. Tell me M25 ratio
Ans. 
M25 ratio refers to the mix ratio of concrete, commonly used in construction projects.
• M25 ratio is 1:1:2, which means 1 part cement, 1 part sand, and 2 parts aggregate.

• This mix is commonly used for structural concrete works like columns, beams, and slabs.

• The strength of concrete with M25 ratio is typically around 25 megapascals after 28 days of curing.
Answered by AI
Add your answer

Q1. What is blinding? Different types of blinds used in o&g?
Ans. 
Blinding is the process of isolating a section of a pipeline or equipment to prevent flow or contamination.
• Temporary or permanent blinds can be used depending on the situation

• Common types of blinds include spectacle blinds, paddle blinds, and bleed rings

• Blinding is often used during maintenance or repair work to ensure safety

• Blinding can also be used to prevent contamination during storage or transportation

• Blinding can...read more
Answered by AI
Add your answer
Q2. Procedures before starting a work in a refinery equipment,
Ans. 
Before starting work in a refinery equipment, certain procedures must be followed.
• Obtain a work permit

• Perform a safety check of the equipment

• Ensure proper personal protective equipment is worn

• Verify that all valves are in the correct position

• Confirm that the equipment is properly grounded

• Check for any leaks or abnormal conditions

• Communicate with other workers in the area

• Follow all established procedures and protocols
Answered by AI
Add your answer
Q3. What will you do if there's an H2S leak and there's no wind movement,
Ans. 
I will follow the emergency response plan and evacuate the area immediately.
• Activate the alarm system to alert others in the area

• Put on personal protective equipment (PPE) including a respirator

• Evacuate the area immediately and move to a safe location

• Notify emergency services and follow the emergency response plan

• Monitor the situation and wait for the all-clear signal before returning to the area
Answered by AI
Add your answer
Q4. From where you'll advice your workers to start unbloting a heat exchanger head?
Ans. 
I would advise my workers to start unbolting the heat exchanger head from the top and work their way down.
• Start from the top and work your way down

• Use appropriate tools and safety equipment

• Follow proper procedures and guidelines

• Ensure all bolts are properly labeled and accounted for

• Inspect the gasket and replace if necessary
Answered by AI
Add your answer

CFBC Boiler related questions