MRF Tyres Graduate Engineer Trainee (Get) Interview Questions and Answers

40 students were shortlisted for this round. Only aptitude questions, 1 hour test

27 were shortlisted for this then 3 groups of 9 were formed and topic was AI vs human intelligence. 12 were shortlisted for PI

Q1. Initially started with CV, then going deep in favourite subjects. Conceptual questions Few HR questions 5 were shortlisted for psychometric test
Add your answer
Q2. Laminar flow, Reynolds no, turbine structure, bernaulli's equations for turbine
Add your answer
Q3. Stress strain diagram, it's area and other related questions
Add your answer
Q4. Scavenging, engine efficiency, truss, degree of freedom, b-spline curve, bezier curve and surface
Add your answer

Q1. Two psychometric test conducted and 4 were offered job.
Add your answer

Q1. The test was conducted in online.The test contains 100 questions.But it will take more time to complete everything.
Add your answer

Q1. What is the angle of a drill bit?
Ans. 
The angle of a drill bit refers to the angle between the cutting edge of the drill bit and the surface being drilled.
• The angle of a drill bit is typically measured in degrees.

• Common drill bit angles include 118 degrees for general purpose drilling and 135 degrees for drilling harder materials.

• The angle of the drill bit affects the performance and efficiency of the drilling process.

• Different types of drill bits have dif...read more
Answered by AI
Add your answer
Q2. Tell the type of machining process and type of material used in cutting tool?
Ans. 
Machining process involves cutting, shaping, or finishing materials using a cutting tool. Common types include turning, milling, drilling, and grinding.
• Types of machining processes: turning, milling, drilling, grinding, etc.

• Types of materials used in cutting tools: high-speed steel, carbide, ceramic, diamond, etc.

• Examples: Turning - using a lathe to rotate a workpiece and cut material with a single-point cutting tool.

• M...read more
Answered by AI
Add your answer

Q1. Defects in plastic parts
Ans. 
Defects in plastic parts can be caused by various factors such as design flaws, material impurities, and manufacturing errors.
• Common defects include warping, sink marks, flash, and short shots.

• Design flaws can lead to weak spots or improper fitment.

• Material impurities can cause discoloration, bubbles, or poor surface finish.

• Manufacturing errors like improper cooling or injection pressure can result in defects.

• Quality c...read more
Answered by AI
Add your answer
Q2. What is undercut
Ans. 
Undercut is a hairstyle where the hair on the top of the head is longer than the sides and back.
• Undercut involves shaving or cutting the sides and back of the head short while leaving the top longer

• Popular among both men and women

• Can be styled in various ways such as slicked back, pompadour, or messy

• Celebrities like Brad Pitt and Miley Cyrus have been seen sporting undercuts
Answered by AI
Add your answer