JSW Bhushan Power & Steel Interview Questions, Process, and Tips for Experienced

Q1. Boiler interlock.
Add your answer

Q1. Boiler tripping parameters.
Ans. 
Boiler tripping parameters are specific conditions that cause a boiler to shut down automatically for safety reasons.
• Boiler pressure exceeding safe limits

• Low water level in the boiler

• Flame failure or loss of ignition

• High furnace temperature

• Excessive steam temperature or pressure
Answered by AI
Add your answer

Q1. Induction furnace eot crane
Ans. Induction furnace maintenance stand by crusible all general chaking
Answered by Munna Singh
View 1 more answer
Q2. Eot crane preventive maintenance shutdown work and all general chaking
Ans. Eot crane preventive maintenance Chaking oil level in thruster Chaking of wire rope condition Oil level in gear box Break setting chaking of wire rope lubrication Chaking gear coupling nut 🔩 bolt lt & ct main host rail & structure chaking proper house keeping wanted meterial all beating greasing Shutdown work planing Main host wire rope change .and rail and structure work
Answered Anonymously
Add your answer
Q3. Cooling tower maintenance and preventive maintenance shutdown work
Add your answer
Q4. Furnace coil cooling water pump preventive maintenance shutdown work
Ans. Chaking of unwanted noise and vibration Chaking bearing condition Chaking of shaft alignment and clearance Suction and discharge pressure Bearing lubrication level Corrosion and Dirt chaking
Answered by Munna Singh
Add your answer
Q5. Hydraulic power pack system maintenance
Add your answer
Q6. All main power work distribution
Ans. 
Main power work distribution involves managing the distribution of electrical power throughout a construction site.
• Coordinate with electricians to ensure proper installation and maintenance of power distribution systems

• Monitor power usage and troubleshoot any issues that arise

• Ensure compliance with safety regulations and protocols

• Plan for future power needs and upgrades

• Examples: overseeing the installation of temporary...read more
Answered by AI
Add your answer

Q1. All control wireing and power wireing all dcs plc work going on
Add your answer
Q2. Automation rooling mill division jamshedpur
Add your answer

Q1. I am electrical engineer working on it and found in the same as par required production okay for me to get the same as the motor is overloaded due to the machine running ok but
Add your answer
Q2. Automation work
Add your answer

I am electrical engineer working on it jamshedpur jharkhand steel strips wheel limited jamshedpur jharkhand

Q1. Steel sector .
Add your answer
Q2. Rolling process
Add your answer