Filter interviews by
I applied via Recruitment Consulltant and was interviewed in Feb 2024. There were 3 interview rounds.
Cavitation in pumps is the formation of vapor bubbles in the liquid being pumped due to low pressure, which can lead to damage and reduced efficiency.
Cavitation occurs when the pressure in a pump drops below the vapor pressure of the liquid, causing bubbles to form and collapse violently.
This can result in erosion of pump components, decreased performance, and noise.
Common signs of cavitation include pitting on the imp...
Net Positive Suction Head (NPSH) is a measure of the pressure available at the suction port of a pump.
NPSH is important for ensuring that a pump does not cavitate, which can cause damage to the pump and decrease efficiency.
It is calculated by subtracting the vapor pressure of the fluid from the total suction head.
NPSH is typically provided by the pump manufacturer and must be greater than the required NPSH for the pump...
Buoyancy in a balloon is not affected by the car taking a turn due to the principle of relative motion.
Buoyancy is a force exerted by a fluid that opposes the weight of an immersed object.
The balloon and the air inside it are both moving with the car, so the buoyant force remains constant.
The buoyant force is determined by the displaced fluid, not the motion of the object.
Therefore, the balloon will continue to float i...
Logical reasoning based IQ test for 30 minutes.
I applied via Recruitment Consultant and was interviewed in Jun 2021. There were 5 interview rounds.
posted on 18 Jun 2024
posted on 21 May 2023
I applied via Recruitment Consulltant and was interviewed before May 2022. There were 3 interview rounds.
posted on 22 Jan 2021
FMEA is a risk assessment tool used to identify and mitigate potential failures. CP and CPK are statistical measures of process capability.
FMEA stands for Failure Mode and Effects Analysis
It is used to identify potential failures in a process or product
CP and CPK are statistical measures of process capability
They are used to determine if a process is capable of producing products within specification limits
CPK is a mor...
Industry growth in QMS can be achieved by implementing efficient quality management systems and promoting their benefits.
Developing and implementing effective QMS policies and procedures
Providing training and education to employees on QMS
Encouraging continuous improvement and innovation in QMS
Promoting the benefits of QMS to customers and stakeholders
Ensuring compliance with industry standards and regulations
Collaborat...
posted on 11 May 2024
I applied via Approached by Company and was interviewed before May 2023. There were 2 interview rounds.
SOC refers to the state of charge of a battery, SOH refers to the state of health, pre-charge is the initial charging process, and cell chemistry refers to the type of chemicals used in the battery.
SOC is the amount of charge remaining in a battery, expressed as a percentage of its maximum capacity.
SOH is a measure of a battery's overall health and its ability to hold a charge over time.
Pre-charge is the initial chargi...
I applied via Naukri.com and was interviewed in Jun 2021. There were 3 interview rounds.
I applied via Referral and was interviewed in Aug 2021. There were 2 interview rounds.
based on 3 interviews
Interview experience
based on 22 reviews
Rating in categories
Production Engineer
6
salaries
| ₹0 L/yr - ₹0 L/yr |
Production Manager
5
salaries
| ₹0 L/yr - ₹0 L/yr |
Accounts Manager
5
salaries
| ₹0 L/yr - ₹0 L/yr |
Production Supervisor
5
salaries
| ₹0 L/yr - ₹0 L/yr |
Mechanical Engineer
4
salaries
| ₹0 L/yr - ₹0 L/yr |
Thermax Limited
Su-Kam Power Systems
Blue Star
Kirloskar Brothers