Filter interviews by
I applied via Walk-in and was interviewed before Jan 2023. There were 2 interview rounds.
Protection scheme in transmission and distribution substations ensures safety and reliability of the electrical system.
Protection scheme is a set of devices and systems designed to detect and isolate faults in the electrical system.
It includes various protective relays, circuit breakers, fuses, and other equipment.
The scheme operates based on principles of fault detection, fault isolation, and fault clearance.
Different...
Single line diagram shows electrical distribution system in simplified form. Circuit breaker schemes depict arrangement of circuit breakers in system.
Single line diagram is a simplified representation of electrical distribution system showing how various components are connected.
It includes power sources, loads, transformers, circuit breakers, etc. with lines indicating connections.
Circuit breaker schemes show arrangem...
CT, PT, and CVT are electrical equipment used in power systems for measurement and protection purposes.
CT stands for Current Transformer, which is used to measure and step down high currents to a safe level for measurement or protection devices.
PT stands for Potential Transformer, which is used to measure and step down high voltages to a safe level for measurement or protection devices.
CVT stands for Capacitive Voltage...
Different types of transformers used in substations include power transformers, distribution transformers, and instrument transformers.
Power transformers are used to step up or step down voltage for transmission and distribution purposes.
Distribution transformers are used to supply lower voltage to end users.
Instrument transformers include current transformers and voltage transformers used for metering and protection p...
Various tests are performed on transformers, CTs, and breakers to ensure their proper functioning and safety.
Insulation resistance test to check for any insulation breakdown
Turns ratio test to verify the turns ratio of the transformer
Polarity test to confirm correct polarity
CT ratio test to ensure the current ratio is accurate
Contact resistance test on breakers to check for any loose connections
Timing test on breakers
In case of an emergency in a substation, I would follow established safety protocols and procedures to ensure the safety of personnel and equipment.
Immediately notify the appropriate authorities and emergency services
Evacuate personnel from the affected area to a safe location
Isolate the affected equipment to prevent further damage
Implement contingency plans to maintain power supply if possible
Coordinate with relevant
I applied via Recruitment Consultant and was interviewed in Aug 2019. There were 4 interview rounds.
GE Vernova T&D India interview questions for popular designations
posted on 23 Oct 2021
I applied via Naukri.com and was interviewed in Nov 2020. There were 3 interview rounds.
posted on 10 May 2022
I applied via Approached by Company and was interviewed before May 2021. There were 2 interview rounds.
Piping code and welder qualifications test
Piping code refers to the set of standards and regulations that govern the design, fabrication, and inspection of piping systems.
Welder qualifications test is a process of testing and certifying welders to ensure that they have the necessary skills and knowledge to perform welding tasks safely and effectively.
Both piping code and welder qualifications test are important in ensu...
Some of the top questions asked at the GE Vernova T&D India interview -
based on 5 interviews
Interview experience
based on 360 reviews
Rating in categories
Project Manager
46
salaries
| ₹6.5 L/yr - ₹24.1 L/yr |
Scada Engineer
24
salaries
| ₹3 L/yr - ₹7.5 L/yr |
Site Manager
23
salaries
| ₹6 L/yr - ₹13 L/yr |
Assistant Manager
22
salaries
| ₹5.5 L/yr - ₹13.5 L/yr |
Quality Engineer
21
salaries
| ₹2.4 L/yr - ₹4 L/yr |
Siemens
ABB
BHEL
Larsen & Toubro Limited