Gala Precision Engineering Limited Assistant Manager Interview Questions and Answers

Q1. Discussion about the profile
Add your answer

Q1. Site reporting manager ask questions as per core relevants.
Add your answer

Q1. Ask all technical questions regarding the core relevant areas
Add your answer

Concerning previous work experience.

Software or tool test

Q1. Related to technical question about fabrication.
Add your answer
Q2. Tool related question
Add your answer

It was a basic 30 minutes aptitude test having topics like Quantitative Analysis, Logical Reasoning, etc.

Q1. Tell me about yourself?
Ans. Hi, my name is "XYZ", I am a "Educational Qualification", completed my Pg / Degree from "University Name" in "Year". Give details about your projects and other extra curricular activities.
Answered Anonymously
Add your answer

Q1. Explain about your projects and other technical aspects of your stream
Ans. Explain in detail about your projects with supporting data
Answered Anonymously
Add your answer

Q1. Steel and shuttering releted questions
Add your answer

Q1. Expectation releted questions
Add your answer

Q1. What is blinding? Different types of blinds used in o&g?
Ans. 
Blinding is the process of isolating a section of a pipeline or equipment to prevent flow or contamination.
• Temporary or permanent blinds can be used depending on the situation

• Common types of blinds include spectacle blinds, paddle blinds, and bleed rings

• Blinding is often used during maintenance or repair work to ensure safety

• Blinding can also be used to prevent contamination during storage or transportation

• Blinding can...read more
Answered by AI
Add your answer
Q2. Procedures before starting a work in a refinery equipment,
Ans. 
Before starting work in a refinery equipment, certain procedures must be followed.
• Obtain a work permit

• Perform a safety check of the equipment

• Ensure proper personal protective equipment is worn

• Verify that all valves are in the correct position

• Confirm that the equipment is properly grounded

• Check for any leaks or abnormal conditions

• Communicate with other workers in the area

• Follow all established procedures and protocols
Answered by AI
Add your answer
Q3. What will you do if there's an H2S leak and there's no wind movement,
Ans. 
I will follow the emergency response plan and evacuate the area immediately.
• Activate the alarm system to alert others in the area

• Put on personal protective equipment (PPE) including a respirator

• Evacuate the area immediately and move to a safe location

• Notify emergency services and follow the emergency response plan

• Monitor the situation and wait for the all-clear signal before returning to the area
Answered by AI
Add your answer
Q4. From where you'll advice your workers to start unbloting a heat exchanger head?
Ans. 
I would advise my workers to start unbolting the heat exchanger head from the top and work their way down.
• Start from the top and work your way down

• Use appropriate tools and safety equipment

• Follow proper procedures and guidelines

• Ensure all bolts are properly labeled and accounted for

• Inspect the gasket and replace if necessary
Answered by AI
Add your answer

Q1. Hr compliance & Licences
Add your answer
Q2. Minimum wages, PF , ESI
Add your answer
Q3. Licenses required
Add your answer

Q1. Discussion about the profile
Add your answer

Q1. Site reporting manager ask questions as per core relevants.
Add your answer

Q1. Ask all technical questions regarding the core relevant areas
Add your answer