Consulting Engineers Group BIM Modeller Interview Questions and Answers

Leveling is the process of determining the height or elevation of a point or surface relative to a reference point.

• Leveling is commonly used in civil engineering and construction to ensure accurate measurements and proper alignment.

• It involves the use of leveling instruments such as a level, theodolite, or laser level.

• The process typically includes setting up benchmarks or reference points, taking readings at different...read more

The diameter of six mm refers to the size or measurement of a circular object that is six millimeters in width.

• The diameter is the distance across the center of a circle, passing through the circumference.

• A six mm diameter can be visualized as a circle with a width of six millimeters.

• It is a common measurement used in various industries, including engineering and manufacturing.

• For example, a six mm diameter steel rod w...read more

LEP stands for Load Equivalent Factor for Pavement design.

• LEP is used in pavement design to determine the load-carrying capacity of the pavement.

• The formula for LEP depends on the specific design method being used.

• For example, in the AASHTO design method, LEP is calculated using the formula: LEP = (ESAL/1000) * (1 + 0.003 * (T - 3))

• Here, ESAL is the Equivalent Single Axle Load and T is the pavement design period in yea...read more

The grade of concrete refers to its strength and is classified based on its compressive strength.

• Concrete grades range from M5 to M100, with M representing mix and the number representing the compressive strength in megapascals (MPa).

• The most commonly used grades of concrete are M20, M25, and M30.

• Higher grade concrete is used for structures that require greater strength, such as bridges and high-rise buildings.

• The grad...read more

Initial setting time of cement is the time taken by cement to harden and attain a particular strength.

• Initial setting time is determined by Vicat apparatus

• It is the time taken for the cement to lose its plasticity and become hard

• The standard initial setting time for ordinary Portland cement is 30 minutes

• Factors affecting initial setting time include temperature, water-cement ratio, and type of cement

The elongation % of steel fy 500 is approximately 12%.

• Elongation % is the measure of ductility of a material.

• It is the percentage increase in length of a material before it fractures under tension.

• For steel fy 500, the elongation % is approximately 12%.

• This means that the steel can stretch up to 12% of its original length before it breaks.

The amount of cement required for 1 cubic meter varies depending on the concrete mix design.

• The amount of cement needed for 1 cubic meter of concrete varies from 250kg to 600kg depending on the mix design.

• The mix design specifies the ratio of cement to other materials like sand and aggregates.

• For example, a mix design of 1:2:4 requires 400kg of cement per cubic meter of concrete.

• It is important to accurately calculate ...read more

Density of materials: Steel - 7850 kg/m3, Concrete - 2400 kg/m3, Sand - 1600 kg/m3

• Density of steel is higher than that of concrete and sand

• Density of concrete varies depending on the mix design

• Density of sand can vary depending on the source and moisture content