Alliance Group Junior Engineer Civil Interview Questions and Answers

The number of bricks in 1 cubic meter varies depending on the size of the bricks used.

• The number of bricks in 1 cubic meter will depend on the size of the bricks being used.

• Standard size bricks (190mm x 90mm x 90mm) will have a different count compared to larger or smaller bricks.

• Calculations can be done by dividing the volume of 1 cubic meter by the volume of a single brick.

Pressure in fire hydrant pipe is determined by factors like water flow rate, pipe diameter, and elevation difference.

• Pressure in fire hydrant pipe is directly related to the flow rate of water through the pipe.

• The diameter of the pipe also affects the pressure, with larger diameter pipes resulting in lower pressure loss.

• Elevation difference between the hydrant and the point of discharge can impact the pressure in the p...read more

NRC stands for National Register of Citizens.

• NRC is a register containing names of all genuine Indian citizens in the state of Assam, India.

• It was first prepared in 1951 and is now being updated to identify illegal immigrants.

• The NRC process involves verifying the citizenship status of individuals based on documents like birth certificates, land records, etc.

RCC work refers to reinforced concrete construction, which involves using steel bars to strengthen concrete structures.

• RCC work involves the use of steel reinforcement bars within concrete to increase its strength and durability.

• It is commonly used in the construction of buildings, bridges, dams, and other structures.

• The steel bars are placed in specific locations within the concrete formwork before pouring the concret...read more

The sequence of activities for aluminium (mivan) structure construction involves several steps.

• Preparing the site and marking the layout

• Constructing the foundation and footings

• Erecting the aluminium formwork panels

• Fixing reinforcement bars and embedment items

• Pouring concrete into the formwork

• Curing the concrete

• Stripping the formwork

• Finishing and cleaning the structure

The finishing work sequence of activities involves the final steps in a construction project to complete the project and prepare it for use.

• Inspecting and correcting any defects or deficiencies

• Installing finishes such as flooring, paint, and fixtures

• Completing final electrical and plumbing work

• Cleaning and tidying up the site

• Obtaining necessary permits and certifications

• Conducting final inspections

• Handing over the comp

Waterproofing ponding test hours determine the duration for which a waterproofing system can withstand water ponding.

• Waterproofing ponding test hours measure the ability of a waterproofing system to resist water penetration under prolonged ponding conditions.

• The test involves subjecting the waterproofing system to a specified water depth for a certain duration.

• The duration of the test can vary depending on the project ...read more

The accepted rolling margin value for 8mm to 10mm steel rods varies depending on the specific project requirements and industry standards.

• The accepted rolling margin value can range from 2% to 5%.

• It is important to consult project specifications and industry guidelines for the specific rolling margin value.

• For example, if the rolling margin value is set at 3%, a 10mm steel rod could have a diameter between 9.7mm and 10...read more

The unit weight of steel refers to the weight of a given volume of steel material.

• The unit weight of steel is typically measured in pounds per cubic foot or kilograms per cubic meter.

• The specific unit weight of steel can vary depending on the type and grade of steel being used.

• For example, the unit weight of structural steel is around 490 pounds per cubic foot or 7850 kilograms per cubic meter.

• The unit weight of reinfo...read more