Filter interviews by
I applied via Approached by Company and was interviewed before Aug 2021. There were 2 interview rounds.
Top trending discussions
I applied via Referral and was interviewed before Mar 2020. There were 3 interview rounds.
posted on 12 Nov 2020
I applied via Company Website and was interviewed in May 2020. There were 3 interview rounds.
MPLS is a protocol used for efficient packet forwarding. It uses labels to identify paths instead of IP addresses.
MPLS stands for Multiprotocol Label Switching
Labels are assigned to packets at the ingress router
Labels are used to identify the path a packet should take through the network
Labels are swapped at each MPLS router along the path
The last MPLS router removes the label and forwards the packet based on the IP ad...
Route reflector is a BGP feature that allows a router to advertise routes to its clients without requiring full mesh connectivity.
Route reflector reduces the number of iBGP peerings required in a network.
It helps in scaling the network by reducing the number of updates and processing required.
Route reflector can be configured in a hierarchical manner to further reduce the number of iBGP peerings.
It is commonly used in ...
I applied via Company Website and was interviewed before Jan 2021. There were 3 interview rounds.
I applied via Referral and was interviewed before Jan 2024. There were 2 interview rounds.
I applied via Campus Placement and was interviewed before Feb 2023. There were 3 interview rounds.
Scope of Renewable energy in India
Current is the flow of electric charge in a circuit.
Current is measured in Amperes (A).
It is the rate of flow of electric charge through a conductor.
Current flows from the positive terminal to the negative terminal in a circuit.
There are two types of current - direct current (DC) and alternating current (AC).
Conductors diameter can be calculated using the formula: diameter = sqrt((4 * area) / pi)
Calculate the area of the conductor (usually circular) using the formula: area = pi * (radius^2)
Determine the radius of the conductor
Use the formula: diameter = sqrt((4 * area) / pi) to calculate the diameter
I applied via Campus Placement and was interviewed before Nov 2022. There were 3 interview rounds.
Any topic such as bullet train, race, education, GSt etc
The ratio of cement, sand, and aggregate in M20 concrete is 1:1.5:3.
The ratio of cement to sand to aggregate is 1:1.5:3 in M20 concrete.
For every 1 part of cement, 1.5 parts of sand and 3 parts of aggregate are used.
This ratio ensures the desired strength and workability of the concrete mix.
based on 4 interviews
Interview experience
based on 99 reviews
Rating in categories
Design Engineer
33
salaries
| ₹0 L/yr - ₹0 L/yr |
Production Engineer
15
salaries
| ₹0 L/yr - ₹0 L/yr |
QA Engineer
9
salaries
| ₹0 L/yr - ₹0 L/yr |
Shift Engineer
9
salaries
| ₹0 L/yr - ₹0 L/yr |
Production Planning Control Engineer
8
salaries
| ₹0 L/yr - ₹0 L/yr |
Adani Transmission
Power Grid Corporation of India
Sterlite Power
Tata Power