i
Medha Servo Drives
Filter interviews by
I applied via Campus Placement and was interviewed before Jan 2022. There were 2 interview rounds.
Descriptive test, Electric circuits, C, Apptitude basics.
My BTech project was on developing a smart irrigation system using IoT technology.
The project aimed to optimize water usage in agriculture by using sensors to detect soil moisture levels and weather conditions.
The system would then automatically adjust the amount of water delivered to the crops through a network of valves and pumps.
I used Arduino boards and Raspberry Pi for the hardware, and programmed the system using...
Top trending discussions
posted on 23 May 2022
I applied via Referral and was interviewed before May 2021. There were 2 interview rounds.
posted on 13 Apr 2015
posted on 21 Mar 2025
I appeared for an interview in Feb 2025, where I was asked the following questions.
Half wave and full wave rectifiers convert AC to DC, differing in efficiency and output waveform.
Half Wave Rectifier: Uses one diode, allows only one half of AC waveform.
Example: Simple power supply for low-power devices.
Full Wave Rectifier: Uses two or four diodes, utilizes both halves of AC waveform.
Example: More efficient power supply for higher power devices.
Half wave produces pulsating DC, while full wave produces
Filtering signals with ripples involves using techniques to reduce unwanted oscillations while preserving desired signal characteristics.
Use a low-pass filter to attenuate high-frequency ripples while allowing low-frequency signals to pass.
Apply a moving average filter to smooth out rapid fluctuations in the signal.
Consider using a Butterworth filter for a smooth frequency response with minimal ripples.
Employ a Kalman ...
I applied via Campus Placement and was interviewed in Mar 2022. There were 3 interview rounds.
The question were asked on project and the resume details
posted on 8 Jan 2024
I applied via Campus Placement and was interviewed in Dec 2023. There were 2 interview rounds.
Its a mn online aptitude test comprising of 30 aptitude questions and 30 technical questions in total 60 questions.
The technical question background depends upon your stream like [EEand EC , ME]
The time is give of 60min to complete the test.
posted on 19 Mar 2023
I applied via Campus Placement and was interviewed in Feb 2023. There were 2 interview rounds.
Technical + Aptitude Test. Minimum 50% to qualify for 2nd round.
Factor of Safety, Fatigue failure, Stress, failure theories are important concepts in engineering.
Factor of Safety is the ratio of the maximum stress a material can withstand to the working stress.
Fatigue failure occurs when a material fails due to repeated loading and unloading.
Stress is the force per unit area that a material is subjected to.
Failure theories are used to predict the failure of a material under differe...
posted on 28 Oct 2023
I applied via Campus Placement and was interviewed before Oct 2022. There were 3 interview rounds.
Basic IQ questions very easy
1 Tr of refrigeration is the amount of heat required to melt 1 ton of ice in 24 hours.
1 Tr of refrigeration is equal to 12,000 BTU/hr or 3.517 kilowatts.
Newtonian fluids have constant viscosity, while non-Newtonian fluids have variable viscosity.
Psychometric chart is a graphical representation of the thermodynamic properties of air-water mixtures.
Entropy is a measure of the disorder or randomness in a system, while ent...
based on 4 interviews
2 Interview rounds
based on 1 review
Rating in categories
Service Engineer
250
salaries
| ₹1.8 L/yr - ₹8 L/yr |
Junior Engineer
187
salaries
| ₹3 L/yr - ₹6.5 L/yr |
Technical Assistant
118
salaries
| ₹1.8 L/yr - ₹7.2 L/yr |
Engineer
101
salaries
| ₹3 L/yr - ₹12 L/yr |
Assistant Engineer
73
salaries
| ₹4.5 L/yr - ₹9 L/yr |
Havells
Polycab Wires
CG Power and Industrial Solutions
C&S Electric