Filter interviews by
Clear (1)
Factor of safety is a design parameter that accounts for uncertainties in material properties and loading conditions.
Factor of safety is the ratio of the maximum stress a material can withstand to the maximum stress it is subjected to in a given application.
It ensures that the structure or component will not fail under normal operating conditions.
Higher factor of safety values indicate a more conservative design approa...
Tolerance refers to the allowable variation in dimensions or properties of a part or product.
Tolerance is important in engineering to ensure proper fit and function of components.
It is typically specified as a range of acceptable values, such as +/- 0.1mm.
Tolerance can be applied to dimensions, material properties, surface finish, etc.
For example, a hole may have a tolerance of +/- 0.05mm to allow for proper alignment
I applied via Company Website and was interviewed in Sep 2023. There was 1 interview round.
I applied via Company Website and was interviewed in Jan 2023. There were 3 interview rounds.
Top trending discussions
Baud rate is the rate at which data is transmitted over a communication channel.
Baud rate is measured in bits per second (bps).
Higher baud rates allow for faster data transmission.
Baud rate must be set the same on both ends of the communication channel.
Incorrect baud rate settings can result in data corruption or loss.
Examples of communication channels that use baud rate include UART, SPI, and I2C.
I2C is a serial communication protocol used to connect multiple devices with two wires. Pull-up resistors are necessary for proper communication.
I2C uses a master-slave architecture where the master initiates communication.
Each device on the bus has a unique address assigned to it.
Data is transmitted in packets with a start and stop bit.
Pull-up resistors are necessary to ensure proper voltage levels on the bus.
The valu...
Moment and shear force diagrams are graphical representations of the internal forces acting on a structural element.
Moment diagram shows the variation of bending moment along the length of the beam.
Shear force diagram shows the variation of shear force along the length of the beam.
Both diagrams are essential for designing and analyzing structures.
They help in determining the maximum bending moment and shear force that ...
posted on 29 Mar 2023
I applied via Campus Placement and was interviewed before Mar 2022. There were 3 interview rounds.
I applied via Company Website and was interviewed before Jun 2023. There was 1 interview round.
Major resistance by old method involves using traditional techniques to determine the level of resistance in a material.
Use manual testing methods such as scratch testing or hardness testing to assess resistance
Refer to historical data or records of similar materials for comparison
Consult with experienced professionals who have knowledge of traditional resistance testing methods
posted on 28 Feb 2024
Was asked to write a program for linked list
posted on 21 Dec 2024
I applied via Recruitment Consulltant and was interviewed before Dec 2023. There were 3 interview rounds.
Interceptor concepts
based on 5 interviews
Interview experience
based on 32 reviews
Rating in categories
Senior Manager
191
salaries
| ₹0 L/yr - ₹0 L/yr |
Design Engineer
150
salaries
| ₹0 L/yr - ₹0 L/yr |
Trainee
145
salaries
| ₹0 L/yr - ₹0 L/yr |
Graduate Apprenticeship Trainee
144
salaries
| ₹0 L/yr - ₹0 L/yr |
Manager
114
salaries
| ₹0 L/yr - ₹0 L/yr |
Bharat Electronics
Hindustan Shipyard
Mazagon Dock
BHEL