GlobalLogic Junier Engg Interview Questions, Process, and Tips

An energy band is a range of allowed energy levels for electrons in a solid material.

• Energy bands are formed due to the arrangement of atoms in a solid material.

• There are two types of energy bands: valence band and conduction band.

• Valence band is the band of energy levels occupied by electrons in their ground state.

• Conduction band is the band of energy levels above the valence band that electrons can move into.

• The ener...read more

A P-N junction is a boundary between a P-type and N-type semiconductor material.

• It is a fundamental building block of many electronic devices.

• It is formed by doping one side of a semiconductor crystal with impurities of a different type.

• It allows the flow of current in only one direction.

• It is used in diodes, transistors, solar cells, and LEDs.

• The depletion region is formed at the junction due to the diffusion of charg

A rectifier is an electronic device that converts AC to DC.

• Rectifiers are used in power supplies to convert AC voltage to DC voltage.

• They are commonly used in electronic devices such as radios, televisions, and computers.

• There are two types of rectifiers: half-wave and full-wave.

• Half-wave rectifiers only allow half of the AC waveform to pass through, while full-wave rectifiers allow the entire waveform to pass through.

• ...read more

The heavily doped region of a transistor is the emitter region.

• The emitter region of a transistor is heavily doped to increase its conductivity.

• Heavily doping the emitter region allows for efficient injection of majority carriers into the base region.

• The heavily doped emitter region helps in achieving a high current gain in a transistor.

• Examples of heavily doped materials used in the emitter region include N+ or P+ typ

A DC amplifier is an electronic device that amplifies direct current (DC) signals without changing their frequency.

• DC amplifiers are used in various applications such as audio amplification, instrumentation, and control systems.

• They are designed to amplify DC signals accurately and without distortion.

• DC amplifiers typically have a high input impedance and low output impedance.

• They can be implemented using different amp...read more

CMMR stands for Common Mode Rejection Ratio.

• CMMR is a measure of how well a differential amplifier rejects common-mode signals.

• It indicates the ability of an amplifier to suppress unwanted noise or interference.

• A higher CMMR value indicates better rejection of common-mode signals.

• CMMR is expressed in decibels (dB).

• For example, an amplifier with a CMMR of 80 dB can reject common-mode signals 100,000 times smaller than t