Filter interviews by
Top trending discussions
I applied via campus placement at Indian Institute of Technology (IIT), Kanpur and was interviewed in May 2024. There were 2 interview rounds.
1 hr and various apti topics
Gas turbine engines work by compressing air, mixing it with fuel, igniting the mixture, and using the hot exhaust gases to spin a turbine.
Air is drawn into the engine and compressed by a compressor
Fuel is injected and mixed with the compressed air
The mixture is ignited, causing a rapid expansion of gases
The hot exhaust gases are used to spin a turbine, which drives the compressor and generates thrust
Examples: Jet engin
I applied via Naukri.com and was interviewed in Mar 2024. There was 1 interview round.
Sheet metal process involves cutting, bending, and assembling metal sheets to create various products.
Cutting: Using tools like shears, lasers, or plasma cutters to cut the metal sheets into desired shapes
Bending: Utilizing press brakes to bend the metal sheets at specific angles
Assembling: Joining the bent and cut metal sheets together using techniques like welding or fasteners
Finishing: Applying coatings or finishes ...
Types of tolerances include bilateral, unilateral, limit, and fit tolerances.
Bilateral tolerance: Allows for variation in both directions from the nominal dimension.
Unilateral tolerance: Allows for variation in only one direction from the nominal dimension.
Limit tolerance: Specifies the maximum and minimum acceptable limits for a dimension.
Fit tolerance: Determines the acceptable range of tightness or looseness between
Factor of safety is a design parameter that accounts for uncertainties in material properties and loading conditions.
Factor of safety is the ratio of the maximum stress a material can withstand to the maximum stress it is subjected to in a given application.
It ensures that the structure or component will not fail under normal operating conditions.
Higher factor of safety values indicate a more conservative design approa...
Tolerance refers to the allowable variation in dimensions or properties of a part or product.
Tolerance is important in engineering to ensure proper fit and function of components.
It is typically specified as a range of acceptable values, such as +/- 0.1mm.
Tolerance can be applied to dimensions, material properties, surface finish, etc.
For example, a hole may have a tolerance of +/- 0.05mm to allow for proper alignment
posted on 18 May 2024
I applied via Approached by Company and was interviewed in Jan 2023. There were 3 interview rounds.
I applied via AmbitionBox and was interviewed in Jan 2023. There were 3 interview rounds.
Personal information and how about ur journey of the course like what u do in ur college like this
Another general knowledge questions
posted on 22 May 2024
I applied via Referral and was interviewed before May 2023. There were 3 interview rounds.
Upstream regulators control the input flow while downstream regulators control the output flow in a system.
Upstream regulators adjust the pressure or flow rate of the input fluid before it enters a system
Downstream regulators control the pressure or flow rate of the output fluid after it exits a system
Upstream regulators are typically located before the system while downstream regulators are located after the system
Exa...
posted on 29 Mar 2023
I applied via campus placement at Vellore Institute of Technology (VIT) and was interviewed before Mar 2022. There were 3 interview rounds.
I applied via Referral and was interviewed before Feb 2023. There was 1 interview round.
Executive
67
salaries
| ₹3 L/yr - ₹7.5 L/yr |
Associate
48
salaries
| ₹1.7 L/yr - ₹5 L/yr |
Senior Executive
47
salaries
| ₹6 L/yr - ₹10 L/yr |
Assistant Manager
45
salaries
| ₹6 L/yr - ₹16.5 L/yr |
Junior Executive
42
salaries
| ₹3 L/yr - ₹5.5 L/yr |
AIRBUS
Tata Lockheed Martin Aerostructures
Boeing
Hindustan Aeronautics