Filter interviews by
I applied via Recruitment Consulltant and was interviewed in May 2023. There were 2 interview rounds.
Asking about isometric drawing
There are several types of flanges used in pipe fabrication.
Weld Neck Flange
Slip-On Flange
Socket Weld Flange
Threaded Flange
Blind Flange
Lap Joint Flange
To fit up a valve, follow these steps: measure and mark the pipe, cut the pipe, deburr the edges, clean the pipe and valve, apply pipe dope or Teflon tape to the threads, align the valve with the pipe, tighten the valve onto the pipe using a wrench.
Measure and mark the pipe where the valve will be installed
Cut the pipe using a pipe cutter or saw
Deburr the edges of the pipe to remove any sharp or rough edges
Clean the pi...
Pipe schedule refers to the thickness of a pipe wall and is used to determine the pressure capacity and strength of the pipe.
Pipe schedule is a standardized system used to classify the thickness of pipes.
It is denoted by a number followed by the letter 'S', such as Schedule 40 or Schedule 80.
The higher the schedule number, the thicker the pipe wall and the higher the pressure capacity.
Pipe schedule is important in indu...
Top trending discussions
Electrical Engineer
9
salaries
| ₹10.2 L/yr - ₹22 L/yr |
Mechanical Engineer
9
salaries
| ₹5.6 L/yr - ₹20 L/yr |
Safety Officer
7
salaries
| ₹4.5 L/yr - ₹12.3 L/yr |
Safety Engineer
7
salaries
| ₹5 L/yr - ₹11 L/yr |
HSE Officer
6
salaries
| ₹6.5 L/yr - ₹15 L/yr |
TCS
Infosys
Wipro
HCLTech