Ashapura Group Of Industries Maintenance Engineer Interview Questions and Answers

Q1. BELT joint, alignment, bearing replacement and inspection work
Add your answer
Q2. Crusher pm stackers cum reclaimer paddle FEEDER and any other pm work procedure
Add your answer

Basic engineering questions

Q1. Basic of mechanical engineering questions (basic knowledge testl
Add your answer
Q2. Least count of vernier caliper
Ans. 
The least count of a vernier caliper is the smallest measurement that can be read on the scale.
• The least count is typically 0.02 mm or 0.001 inches on a vernier caliper.

• It is determined by dividing the smallest division on the main scale by the total number of divisions on the vernier scale.

• For example, if the main scale has divisions of 1 mm and the vernier scale has 50 divisions, the least count would be 0.02 mm.
Answered by AI
Add your answer
Q3. 0.02 is the least count
Ans. 
The least count of 0.02 means that the smallest measurement that can be accurately read on the measuring instrument is 0.02 units.
• Least count is the smallest measurement that can be accurately read on a measuring instrument.

• In this case, the least count is 0.02 units, meaning any measurement can be read in increments of 0.02.

• It is important to consider the least count when taking measurements to ensure accuracy.
Answered by AI
Add your answer

Q1. Higher pannel member personal and technical questions
Add your answer
Q2. About my resume and personal questions
Add your answer

Q1. About yourself and accounting questions
Add your answer

Q1. Accounting questions
Add your answer
Q2. Basic accounting
Add your answer
Q3. TDS sections checking Points of Vendor invoice
Ans. 
TDS sections in vendor invoices must be checked for accuracy and compliance.
• Verify if TDS has been deducted as per the correct section of the Income Tax Act

• Check if the TDS rate applied is accurate based on the nature of payment

• Ensure that the TDS amount deducted is correctly mentioned on the invoice

• Confirm that the TDS amount has been deposited to the government within the specified timeline
Answered by AI
Add your answer
Q4. GST intra and inter state
Add your answer

Aptitude round with basic questions

Q1. General Questions related to project
Add your answer
Q2. Project discussion
Add your answer

Technical to your domain, work experience, technology upgradtion with latest trend

Q1. What's your future vision
Add your answer
Q2. Why you want this organization
Add your answer

Q1. Can you provide a basic introduction along with your work experience?
Add your answer