Anup Engineering Quality Engineer Interview Questions, Process, and Tips

Reviewing MTC involves analyzing its content, structure, and compliance with standards.

• Read the MTC thoroughly to understand its purpose and scope.

• Check if the MTC follows the required format and includes all necessary sections.

• Evaluate the content for accuracy, clarity, and completeness.

• Ensure that the MTC complies with relevant standards, regulations, and guidelines.

• Verify if the MTC aligns with the project requireme...read more

The range of pressure gauge used in hydrotest varies depending on the specific application and industry standards.

• The range of pressure gauge typically used in hydrotest can be from 0 to several thousand psi (pounds per square inch).

• The specific range of pressure gauge required for a hydrotest depends on factors such as the maximum expected pressure during the test and the sensitivity needed for accurate measurements.

• F...read more

The identification marking in a plate is typically located in a specific area for easy identification and traceability.

• Identification markings are usually placed in a corner or along the edge of the plate.

• The marking may include information such as the manufacturer's logo, serial number, and material grade.

• The location of the marking should be standardized to ensure consistency and ease of identification.

• The marking sh...read more

PWHT is mandatory for certain thicknesses in quality engineering.

• PWHT stands for Post Weld Heat Treatment.

• It is a process used to relieve residual stresses and improve the mechanical properties of welded joints.

• The thickness at which PWHT becomes mandatory depends on the specific welding code or standard being followed.

• For example, in ASME Section VIII Division 1, PWHT is typically required for carbon steel plates thic...read more

Types of heads in vessel include hemispherical, elliptical, torispherical, and flat heads.

• Hemispherical heads have a half-sphere shape.

• Elliptical heads have an elliptical shape.

• Torispherical heads have a combination of spherical and elliptical shapes.

• Flat heads are completely flat.