Asahi India Glass Associate Quality Assurance Engineer Interview Questions and Answers

Q1. What is toe in out please describe
Ans. 
Toe in and toe out are terms used to describe the angle of the wheels on a vehicle.
• Toe in refers to the front of the wheels being closer together than the back of the wheels.

• Toe out refers to the front of the wheels being further apart than the back of the wheels.

• Toe in/out can affect the handling and tire wear of a vehicle.

• Proper alignment is important for safety and optimal performance.
Answered by AI
View 2 more answers
Q2. What is wheel balancing
Ans. 
Wheel balancing is the process of equalizing the weight of a tire and wheel assembly so that it spins smoothly at high speeds.
• It involves adding or removing weights to the wheel to balance it

• Unbalanced wheels can cause vibrations, uneven tire wear, and steering issues

• It is important to balance wheels regularly, especially after getting new tires or wheels

• Examples of wheel balancing equipment include wheel balancers and
Answered by AI
View 3 more answers
Q3. What is Caster camber angle
Ans. 
Caster camber angle is the angle between the vertical axis of the wheel and the steering axis.
• It affects the stability and handling of the vehicle.

• Caster angle helps in straight-line stability and steering returnability.

• Camber angle helps in tire wear and cornering ability.
Answered by AI
Add your answer

Q1. What are about Welding defect
Ans. 
Welding defects are imperfections that occur during the welding process.
• Common welding defects include porosity, undercutting, and incomplete fusion.

• Porosity is caused by gas pockets trapped in the weld, while undercutting is a groove at the base of the weld.

• Incomplete fusion occurs when the weld metal does not fuse completely with the base metal.

• Welding defects can weaken the weld and compromise its integrity.

• Quality ...read more
Answered by AI
Add your answer
Q2. Vernier caliper least count
Ans. 
Vernier caliper least count is the smallest measurement that can be read on the scale of the caliper.
• The least count of a Vernier caliper is usually 0.02 mm or 0.05 mm.

• It is determined by dividing the smallest division on the main scale by the number of divisions on the Vernier scale.

• For example, if the smallest division on the main scale is 1 mm and there are 20 divisions on the Vernier scale, the least count would be
Answered by AI
Add your answer
Q3. Measuring instruments
Add your answer
Q4. What type of welding
Ans. 
The type of welding used depends on the material being welded and the desired strength of the joint.
• Common types of welding include MIG, TIG, stick, and flux-cored welding.

• MIG welding is often used for welding aluminum and steel.

• TIG welding is commonly used for welding thin materials and for precision welding.

• Stick welding is often used for welding thicker materials and in outdoor environments.

• Flux-cored welding is sim...read more
Answered by AI
Add your answer

What your view on alcohol and alcohol bane or not and why

Q1. Quality in process like this PPAP, QC
Ans. PPAP :- ( Part production Approvel process) this is Quality in-process any one components,pist report, CMM report,Sop , process sheet, poka yoke sheet, spot integrity report, process parameters report, Quality control, etc. Submit to costumer end
Answered Anonymously
Add your answer
Q2. Different between rework and repear ?
Ans. Rework is a extra material remove on components like this spot burr , Rusty, threading taping,etc.. Repear is a diffective components in extra material add that is ready for ok components
Answered Anonymously
Add your answer