Texas Instruments Interview Questions, Process, and Tips

The test was easy to moderate and with more questions on passages

Q1. Series combination of resistor
Ans. 
In a series combination of resistors, the total resistance is the sum of individual resistances.
• Total resistance is calculated by adding the individual resistances in the series.

• Current remains the same throughout the series combination.

• Voltage is divided among the resistors based on their individual resistances.
Answered by AI
Add your answer
Q2. Equipotential nodes
Add your answer

RC Ckts basic Qs, Network theory, Analog basic

Q1. RC ckts basic qs
Add your answer
Q2. CMOS inverter characteristics
Ans. 
CMOS inverter is a fundamental building block in digital integrated circuits, with characteristics like high input impedance, low output impedance, and high gain.
• CMOS inverter consists of a PMOS and NMOS transistor connected in series.

• It has high input impedance due to the PMOS transistor and low output impedance due to the NMOS transistor.

• The voltage transfer characteristic of a CMOS inverter is typically nonlinear.

• It...read more
Answered by AI
Add your answer
Q3. Op-amp based circuit solving
Add your answer

Basic Aptitude question

Q1. Included basic level of digital design concepts
Add your answer

Q1. Multiplexers,clock divider
Add your answer

Genreal apptitude questions

Q1. Difference between latch and flipflop
Ans. 
Latch is level triggered, while flip-flop is edge triggered. Latch is asynchronous, while flip-flop is synchronous.
• Latch is level triggered, meaning it changes output when the input signal is high or low continuously.

• Flip-flop is edge triggered, meaning it changes output only on the rising or falling edge of the clock signal.

• Latch is asynchronous, meaning the output changes as soon as the input changes.

• Flip-flop is syn...read more
Answered by AI
Add your answer