Micron Electricals Sr.Electrical Project Engineer Interview Questions and Answers

Q1. Process of W. T. P
Ans. 
The process of Water Treatment Plant (W.T.P) involves various stages to purify water for consumption.
• 1. Coagulation: Adding chemicals to water to make particles clump together.

• 2. Sedimentation: Allowing the clumped particles to settle at the bottom.

• 3. Filtration: Passing water through filters to remove remaining particles.

• 4. Disinfection: Adding chlorine or other chemicals to kill bacteria and viruses.

• 5. Distribution: ...read more
Answered by AI
Add your answer
Q2. About safety precautions
Add your answer

Q1. Salary discussion
Add your answer

Q1. What is SFRA test on power transformer?
Ans. 
SFRA test is a diagnostic test performed on power transformers to assess their mechanical and electrical integrity.
• SFRA stands for Sweep Frequency Response Analysis.

• It is a non-intrusive test that measures the frequency response of a transformer to a swept sinusoidal input signal.

• The test helps in identifying mechanical and electrical faults in the transformer windings.

• SFRA test results can be compared with baseline me...read more
Answered by AI
View 1 more answer

Q1. Which grade of concrete normal use for rcc
Ans. 
The grade of concrete normally used for RCC is M20.
• The grade of concrete for RCC (Reinforced Cement Concrete) is determined based on the design requirements and structural considerations.

• The most commonly used grade of concrete for RCC is M20, which means the concrete mix has a compressive strength of 20 megapascals (MPa) after 28 days of curing.

• Other grades of concrete like M25, M30, M35, etc., can also be used depend...read more
Answered by AI
View 1 more answer
Q2. What are the pre initiative action for start pilling
Ans. 
Pre-initiative actions for start piling
• Conduct a geotechnical investigation to assess soil conditions

• Obtain necessary permits and approvals from local authorities

• Develop a detailed piling plan and schedule

• Procure required piling equipment and materials

• Ensure safety measures are in place for workers and surrounding areas

• Prepare the site by clearing any obstacles or debris

• Establish proper communication channels with stak...read more
Answered by AI
View 1 more answer

Q1. What is the duration for deshuttering a beam of span 4 mtr
Ans. 
The duration for deshuttering a beam of span 4 mtr depends on various factors.
• The type of formwork used for shuttering the beam

• The strength of the concrete used

• The ambient temperature and humidity

• The curing process followed

• The complexity of the beam design

• The availability of manpower and equipment

• Typically, deshuttering can take anywhere from 7 to 21 days for a beam of span 4 mtr
Answered by AI
View 1 more answer
Q2. What is the procedure to define one way and two way slab.How you will fix the reinforcement for two way slab
Ans. 
To define one way and two way slab, we follow different procedures. For two way slab, reinforcement is fixed in both directions.
• One way slab is defined as the slab in which the ratio of longer span to shorter span is greater than or equal to 2.

• Two way slab is defined as the slab in which the ratio of longer span to shorter span is less than 2.

• For two way slab, reinforcement is fixed in both directions to distribute the...read more
Answered by AI
Add your answer
Q3. Longer span/ shorter span less than or equal to 2 is called one way slab,more than 2 is called two way slab.In one way slab main bar placeing should be shorter detection & two way slab main bar should be...read more
Add your answer

Q1. Sewerage System - Design Standards
Ans. 
Design standards for sewerage system
• Design standards vary based on location and regulations

• Consideration should be given to factors such as population density, topography, and soil type

• Standards may include minimum pipe diameter, slope, and depth

• Examples of design standards include ASCE 15 and EPA guidelines
Answered by AI
Add your answer
Q2. Load distribution method
Add your answer

Q1. About the Projects
Add your answer
Q2. Project Planning
Add your answer

Hi this sudhir here a diploma holder in civil high rise building construction .I know the grade of concrete for building construction and finishing work knowledge also I have.

Q1. Why we mix addmixture in concrete
Ans. 
Admixtures are added to concrete to improve its properties and performance.
• Admixtures enhance the workability and durability of concrete.

• They can reduce the water content required for a given slump, making the concrete more cohesive.

• Admixtures can accelerate or retard the setting time of concrete.

• They improve the strength, durability, and resistance to chemical attack of concrete.

• Examples of admixtures include water re...read more
Answered by AI
View 1 more answer
Q2. What is M25 cube strangth
Ans. 
M25 cube strength refers to the compressive strength of concrete with a mix ratio of 1:1:2.
• M25 cube strength is a measure of the ability of concrete to withstand compression.

• It is denoted by the characteristic strength of a concrete cube tested at 28 days.

• M25 grade concrete has a mix ratio of 1:1:2 (cement:sand:aggregate).

• The cube strength of M25 concrete is typically around 25 MPa or 3625 psi.

• It is important for struc...read more
Answered by AI
View 1 more answer

Q1. Say about your any great achievement during your previous constitution professional experience & what was affort made by you?
Add your answer
Q2. Why you think that you are suitable for this position?
Add your answer
Q3. Your further most carrier goals?
Ans. 
My further most career goal is to become a director of project management.
• To gain experience in managing large-scale projects

• To develop leadership and communication skills

• To build a strong network of industry professionals

• To continuously learn and stay updated with industry trends

• To achieve PMP certification

• To work towards becoming a subject matter expert in project management

• To mentor and train junior project managers

• ...read more
Answered by AI
Add your answer