Filter interviews by
Gas charging is done to ensure proper functioning and efficiency of refrigeration systems.
Gas charging is the process of adding refrigerant gas to a refrigeration system.
It is necessary to maintain the correct amount of refrigerant in the system for optimal performance.
Gas charging helps in achieving the desired cooling effect and temperature control.
It also helps in preventing compressor damage due to low refrigerant ...
To check proper voltage, use a multimeter to measure voltage at the source and at the appliance.
Use a multimeter to measure voltage at the source and at the appliance
Check the voltage rating of the appliance to ensure it matches the source
Ensure the voltage is within the acceptable range for the appliance
Check for loose or damaged wiring that could affect voltage
The locations at the back side need to be checked.
Check for any leaks or damage to the refrigerant lines
Inspect the condenser coils for any dirt or debris buildup
Ensure that the fan motor is functioning properly
Check the compressor for any signs of wear or damage
Inspect the evaporator coils for any frost buildup or blockages
Sweating problem in refrigeration can be caused by various factors.
Check for proper insulation
Ensure proper ventilation
Check for refrigerant leaks
Check for clogged air filters
Check for faulty thermostat
Check for overloading of the refrigeration unit
Checking biometal and timer is a routine task for a refrigeration technician.
Inspect biometal for any signs of damage or wear.
Check timer settings and ensure they are functioning properly.
Replace biometal or timer if necessary.
Ensure proper calibration of biometal and timer for optimal performance.
A solution for solving the Rubik's cube
Use the layer-by-layer method
Solve the first layer cross
Solve the first layer corners
Solve the second layer
Solve the third layer cross
Solve the third layer corners
Orient the third layer corners
Permute the third layer corners
Permute the third layer edges
I am open to working in any location as long as the job is challenging and rewarding.
Open to relocation
Prioritize job satisfaction over location
Flexible with work arrangements
A wire harness is a collection of wires, cables, and connectors that transmit electrical signals and power between different components in a system.
Wire harnesses provide a neat and organized way to route and protect wires in a system.
They ensure proper connectivity and prevent wire damage or short circuits.
Wire harnesses simplify troubleshooting and maintenance by allowing easy identification and replacement of faulty...
Sputtering is a process used in manufacturing to deposit thin films of material onto a surface.
Sputtering is a physical vapor deposition technique.
It involves bombarding a target material with high-energy ions or atoms.
This bombardment dislodges atoms from the target material, which then deposit onto a substrate.
Sputtering is commonly used in the production of semiconductor devices, solar cells, and thin film coatings.
...
I applied via Other and was interviewed before Dec 2016. There were 4 interview rounds.
I was interviewed in Mar 2017.
based on 3 reviews
Rating in categories
Assistant Manager
392
salaries
| ₹0 L/yr - ₹0 L/yr |
Sales Executive
297
salaries
| ₹0 L/yr - ₹0 L/yr |
Deputy Manager
293
salaries
| ₹0 L/yr - ₹0 L/yr |
Senior Engineer
288
salaries
| ₹0 L/yr - ₹0 L/yr |
Team Lead
219
salaries
| ₹0 L/yr - ₹0 L/yr |
Samsung
Sony
Whirlpool
Voltas