Cushman & Wakefield Facility Manager Interview Questions and Answers

Soft services cover non-technical aspects of facility management.

• Cleaning and janitorial services

• Pest control

• Landscaping and grounds maintenance

• Security and access control

• Mail and courier services

• Waste management and recycling

• Catering and vending services

• Help desk and reception services

Food and wine serving temperature is crucial for enhancing the taste and aroma.

• White wine should be served chilled between 45-50°F

• Red wine should be served at room temperature between 60-65°F

• Champagne should be served chilled between 40-45°F

• Food should be served at the appropriate temperature to enhance the flavor and texture

• Cold dishes should be served at or below 40°F

• Hot dishes should be served at or above 140°F

Pest control frequency depends on the type of pest, severity of infestation, and facility type.

• Frequency varies from weekly to quarterly depending on the pest and facility.

• Regular inspections and monitoring can help determine the need for pest control.

• Integrated Pest Management (IPM) techniques can reduce the need for frequent pesticide use.

• Emergency pest control may be necessary in case of sudden infestations.

• Document...read more

Deep cleaning is done on a regular basis to maintain hygiene and cleanliness.

• Deep cleaning is usually done quarterly or bi-annually depending on the facility's needs.

• The process involves cleaning hard-to-reach areas, disinfecting surfaces, and removing dirt and grime.

• Special attention is given to high-touch areas such as doorknobs, light switches, and elevator buttons.

• Equipment and machinery are also cleaned and mainta...read more

Transformer oil is crucial for insulating and cooling transformers to ensure efficient operation and prevent breakdowns.

• Transformer oil acts as an insulating medium to prevent electrical breakdowns

• It also helps in cooling the transformer by dissipating heat generated during operation

• Regular testing and maintenance of transformer oil is essential to ensure its effectiveness

• Contaminated or degraded transformer oil can le...read more

Possible reasons for a DG not cranking include dead battery, faulty starter motor, fuel supply issues, or electrical problems.

• Dead battery: Check the battery voltage and connections.

• Faulty starter motor: Test the starter motor for proper functioning.

• Fuel supply issues: Ensure there is enough fuel in the tank and check the fuel lines for blockages.

• Electrical problems: Inspect the wiring and fuses for any damage or fault

There are two main types of energy conversion in a DG set: mechanical energy to electrical energy and chemical energy to mechanical energy.

• Mechanical energy to electrical energy: The diesel engine in the DG set converts the mechanical energy produced by the combustion of diesel fuel into electrical energy through the alternator.

• Chemical energy to mechanical energy: The combustion of diesel fuel in the engine generates ...read more

A UPS diagram shows the components of an uninterruptible power supply system.

• UPS system includes a rectifier, battery, inverter, and bypass switch

• Rectifier converts AC power to DC power to charge the battery

• Battery stores energy to provide power during outages

• Inverter converts DC power from the battery to AC power for devices

• Bypass switch allows power to bypass the UPS during maintenance or failure

Transformer works on the principle of electromagnetic induction to transfer electrical energy between two or more circuits.

• Transformers have two coils of wire, known as primary and secondary coils.

• When an alternating current flows through the primary coil, it creates a changing magnetic field.

• This changing magnetic field induces a voltage in the secondary coil, transferring electrical energy.

• Transformers are used to st...read more

The working principle of a motor involves converting electrical energy into mechanical energy through electromagnetic induction.

• Motors have a coil of wire that carries an electric current, creating a magnetic field

• The magnetic field interacts with a permanent magnet or another coil of wire, causing the motor to turn

• This rotation is used to drive machinery or equipment, such as fans, pumps, or conveyor belts