Filter interviews by
Wire manufacturing processes include drawing, annealing, stranding, and insulation.
Wire manufacturing starts with the drawing process, where a metal rod is pulled through a series of dies to reduce its diameter.
Annealing is then performed to relieve stress and improve the wire's ductility.
Stranding involves twisting multiple wires together to form a cable or conductor.
Insulation is applied to protect the wire and provi...
I applied via Referral and was interviewed in Feb 2021. There was 1 interview round.
posted on 14 Jun 2024
I applied via Walk-in and was interviewed before Jun 2023. There was 1 interview round.
posted on 27 Dec 2024
I appeared for an interview in Jun 2024.
I applied via Naukri.com and was interviewed in Aug 2021. There were 2 interview rounds.
Otto cycle is used in gasoline engines and Diesel cycle is used in diesel engines.
Otto cycle is a constant volume cycle used in gasoline engines.
Diesel cycle is a constant pressure cycle used in diesel engines.
Otto cycle has a higher compression ratio compared to Diesel cycle.
Otto cycle has a spark plug for ignition while Diesel cycle uses compression ignition.
Both cycles involve four processes: intake, compression, po
Stress is the force applied to a material, while strain is the resulting deformation or change in shape.
Stress is a measure of the internal forces within a material, while strain is the measure of the deformation or change in shape.
Stress is typically measured in units of force per unit area (such as N/m^2 or Pa), while strain is a dimensionless quantity.
Stress can cause a material to deform or break, while strain is t...
There are two main types of Ramming mass: acidic and basic.
Acidic Ramming Mass: used for lining induction furnaces and arc furnaces.
Basic Ramming Mass: used for lining steel ladles and EAF (Electric Arc Furnace).
There are several types of steel, each with different properties and uses. The percentage of steel in a particular alloy can vary.
Types of steel include carbon steel, alloy steel, stainless steel, tool steel, and high-speed steel.
The percentage of steel in an alloy can range from as low as 0.2% to as high as 2.1% depending on the type of steel and its intended use.
For example, carbon steel typically contains around 0.2...
First law states energy cannot be created or destroyed, second law states entropy always increases, third law states entropy approaches zero at absolute zero.
First Law: Energy cannot be created or destroyed, only transferred or converted. Example: A car engine converts fuel into mechanical energy.
Second Law: Entropy of an isolated system always increases over time. Example: Heat always flows from hot to cold objects.
Th...
posted on 4 Dec 2024
Material engineer questions
posted on 25 Jun 2024
I applied via Job Fair and was interviewed before Sep 2021. There were 2 interview rounds.
I applied via Company Website and was interviewed before Jan 2021. There were 3 interview rounds.
posted on 29 Jan 2020
based on 1 interview
Interview experience
based on 10 reviews
Rating in categories
Production Engineer
37
salaries
| ₹1.8 L/yr - ₹4.2 L/yr |
Production Supervisor
21
salaries
| ₹1.8 L/yr - ₹2.7 L/yr |
Quality Engineer
14
salaries
| ₹1.8 L/yr - ₹3 L/yr |
Supervisor
9
salaries
| ₹2.2 L/yr - ₹3.2 L/yr |
Maintenance Engineer
9
salaries
| ₹1.9 L/yr - ₹3.3 L/yr |
ArcelorMittal
Tata Steel Downstream Products
Tata BlueScope Steel
Jindal Group Of Companies