WiJungle Interview Questions and Answers

Q1. Are two line segments with coordinates a1,b1 & a2,b2 intersecting or not?
Ans. 
To determine if two line segments with coordinates a1,b1 & a2,b2 intersect, we need to check if the line segments intersect.
• Calculate the slopes of both line segments

• Check if the slopes are equal, if yes, check if the y-intercepts are equal

• If slopes are not equal, calculate the intersection point of the two lines

• Check if the intersection point lies on both line segments
Answered by AI
Add your answer

15 mins was given for aptitude test.

Q1. Networking basics
Add your answer
Q2. Scenario Based Questions
Add your answer

Q1. Why do you want to join?
Ans. 
I am passionate about network security and want to contribute my skills to protect sensitive information.
• Passionate about network security

• Desire to protect sensitive information

• Contribute skills to enhance security measures
Answered by AI
Add your answer
Q2. What are your salary expectations
Ans. 
My salary expectations are in line with industry standards for a Network Security Engineer with my level of experience.
• Research industry standards for Network Security Engineer salaries

• Consider my level of experience and qualifications

• Factor in the cost of living in the area where the job is located

• Be prepared to negotiate based on additional benefits or perks offered
Answered by AI
Add your answer

Q1. Normal dsa problem on binary search
Add your answer
Q2. Logical question
Add your answer

Medium complexity questions mostly quantitative

Trees and Graphs are required to study

Q1. How to do configuration for ipsec if both site to site has same network
Ans. 
Configure IPsec with NAT-T or use different subnets for the site-to-site connections.
• Use NAT-T (Network Address Translation Traversal) to allow both sites to communicate with the same network.

• Alternatively, use different subnets for the site-to-site connections to avoid conflicts.

• Ensure proper routing and firewall rules are in place to allow traffic between the sites.

• Consider using VPN concentrators or routers that sup...read more
Answered by AI
Add your answer
Q2. How to configure rsvp-te in cisco
Ans. 
RSVP-TE can be configured on Cisco routers using the MPLS traffic engineering feature.
• Enable MPLS on the router

• Configure RSVP-TE on the interfaces participating in MPLS TE tunnels

• Define MPLS TE tunnel paths and assign bandwidth constraints

• Verify the configuration using show commands
Answered by AI
Add your answer