VE Commercial Vehicles Supplier Quality Assurance Engineer Interview Questions and Answers

In a gear, we measure various parameters such as pitch diameter, tooth thickness, backlash, and runout.

• Pitch diameter is measured using a gear measuring machine or by calculating it from the number of teeth and the module or diametral pitch.

• Tooth thickness is measured using a gear tooth vernier caliper or a gear tooth micrometer.

• Backlash is measured by placing a dial indicator on the gear teeth and measuring the moveme...read more

Fr and Ff transmission are two different types of transmissions used in vehicles.

• Fr transmission stands for Front-engine, Rear-wheel drive transmission, where the engine is located in the front of the vehicle and power is transmitted to the rear wheels.

• Ff transmission stands for Front-engine, Front-wheel drive transmission, where the engine is located in the front of the vehicle and power is transmitted to the front wh...read more

Various parts of an engine and a transmission and their roles

• Engine parts: pistons, crankshaft, camshaft, valves, spark plugs

• Transmission parts: gears, clutch, torque converter, drive shaft

• Engine parts convert fuel into mechanical energy

• Transmission parts transfer power from the engine to the wheels

Inspection on a CMM and ULM involves using specialized equipment to measure and verify the dimensions and tolerances of a part.

• CMM stands for Coordinate Measuring Machine, which uses a probe to measure the coordinates of points on a part's surface.

• ULM stands for Universal Length Measuring Machine, which uses laser interferometry to measure the length and dimensions of a part.

• To perform inspection on a CMM or ULM, the p...read more

Calibration of measuring instruments like vernier caliper, micrometer, dial gauge, etc.

• Calibration involves comparing the measurements of the instrument with a known standard.

• The process ensures accuracy and reliability of the instrument's measurements.

• Calibration is typically performed by a qualified technician using calibration equipment.

• The technician adjusts the instrument if necessary to align it with the standard...read more

There are 3 types of defects as per QM pillar of TPM: Equipment, Process, and Human. We eliminate them through continuous improvement.

• Equipment defects are caused by malfunctioning or poorly maintained equipment. We can eliminate them by implementing preventive maintenance and conducting regular inspections.

• Process defects are caused by errors in the production process. We can eliminate them by identifying the root cau...read more

PM analysis of TPM involves stages like planning, execution, and evaluation.

• Planning stage involves identifying the objectives, scope, and resources required for TPM analysis.

• Execution stage includes collecting data, analyzing it using statistical tools, and identifying improvement opportunities.

• Evaluation stage focuses on reviewing the results, implementing corrective actions, and monitoring the effectiveness of TPM.

• E...read more

5S is a workplace organization method and 7 QC tools are quality control techniques used in manufacturing.

• 5S is a systematic approach to organizing and maintaining a clean, efficient, and safe work environment.

• The 5S principles are Sort, Set in Order, Shine, Standardize, and Sustain.

• 7 QC tools are a set of statistical techniques used for problem-solving and quality improvement.

• The 7 QC tools include Pareto Chart, Cause...read more