Valmont Structures Detailing Engineer Interview Questions and Answers

The test will be quite easy. They asked question about LCM&HCF,Train and pipe problems which is very important.

The topic is about EV and their evolutions in India.

Q1. Question asked was based on the project and the area of intrest given in resume. Basic question like thin cylinder,stress strain graph ect are also asked.
Add your answer

Questions on logical and quants

Q1. What is Bernoulli principle?
Ans. 
Bernoulli principle states that an increase in the speed of a fluid occurs simultaneously with a decrease in pressure or a decrease in the fluid's potential energy.
• States that as the speed of a fluid increases, its pressure decreases

• Used to explain lift in airplane wings

• Applies to various fluid dynamics situations such as flow through pipes
Answered by AI
Add your answer
Q2. What is stress and how it can be measured?
Ans. 
Stress is a force acting on a material that causes deformation. It can be measured using techniques like strain gauges and load cells.
• Stress is a measure of the internal forces within a material resisting deformation.

• It is typically measured in units of force per unit area, such as Pascals or pounds per square inch.

• Common methods of measuring stress include strain gauges, load cells, and extensometers.

• Stress can be cat...read more
Answered by AI
Add your answer

Questions from transducer digital electronics

Q1. Explain your project
Add your answer

Q1. I didn't selected for HR round
Add your answer

Q1. Why do you want to change ur job
Add your answer
Q2. Y should i hire you?
Add your answer

Q1. Technical related questions
Add your answer
Q2. Technical questions related your branch
Add your answer

Q1. Technical questions
Add your answer

Q1. Technical questions
Add your answer

Q1. Was there a chance of you working on FEA for a particular component and how you achieved the results
Add your answer
Q2. Explain the tool used Boundary conditions Degree of freedom Next higher level situation (assembly constraints)
Ans. 
Boundary conditions, degree of freedom, and assembly constraints are tools used in design engineering to define and analyze the behavior of a system.
• Boundary conditions are constraints that define the limits of a system's behavior or performance.

• Degree of freedom refers to the number of independent parameters that can be varied without violating the constraints of the system.

• Assembly constraints are the restrictions pl...read more
Answered by AI
Add your answer