Filter interviews by
I applied via Approached by Company and was interviewed in Feb 2023. There were 3 interview rounds.
posted on 13 Oct 2023
I applied via Referral and was interviewed before Oct 2022. There were 3 interview rounds.
A transformer is a device that transfers electrical energy between two or more circuits through electromagnetic induction.
Consists of two coils of wire, known as primary and secondary coils
Primary coil is connected to a power source, inducing a magnetic field
Magnetic field causes voltage to be induced in the secondary coil
Used to step up or step down voltage levels in electrical systems
Commonly used in power distributi
posted on 4 Aug 2021
I applied via Walk-in and was interviewed in Feb 2021. There were 4 interview rounds.
posted on 27 Jun 2022
I applied via Company Website and was interviewed in May 2022. There were 2 interview rounds.
Electrical Engineer post can prepare Power sector questions DTR structure LT Line HT line power distribution Cable size Conducter Pole etc
posted on 27 Nov 2024
I applied via Company Website and was interviewed in Oct 2024. There were 2 interview rounds.
MCQ question Electrical & Reasoning
I appeared for an interview in Feb 2024.
posted on 31 Oct 2023
posted on 11 Aug 2021
I applied via Naukri.com and was interviewed before Aug 2020. There was 1 interview round.
A transformer is an electrical device that transfers electrical energy from one circuit to another through electromagnetic induction.
Transformers are used to increase or decrease the voltage of an alternating current (AC) power supply.
They consist of two coils of wire, known as the primary and secondary coils, which are wrapped around a magnetic core.
When an AC voltage is applied to the primary coil, it creates a magne...
posted on 17 Oct 2022
I applied via Walk-in and was interviewed before Oct 2021. There were 3 interview rounds.
25 questions written test of technical education like Transformers principal,etc
I applied via Recruitment Consulltant and was interviewed before Mar 2022. There were 3 interview rounds.
Data required for fire & safety
Building layout and floor plans
Location of fire exits and emergency equipment
Fire suppression systems and equipment
Fire alarm and detection systems
Emergency response plan and procedures
Fittings used during charging depend on the type of refrigerant and system design.
The type of refrigerant and system design determine the fittings used during charging.
Common fittings include flare, sweat, and quick-connect fittings.
Flare fittings are commonly used in air conditioning systems.
Sweat fittings are commonly used in refrigeration systems.
Quick-connect fittings are commonly used in automotive air conditionin...
The depth required for IGL gas laying depends on various factors such as soil type, traffic load, and depth of other utilities.
The depth should be sufficient to prevent damage from external factors such as traffic load and soil type.
The depth should also be deep enough to avoid interference with other utilities.
The depth requirement may vary depending on the location and local regulations.
For example, in Delhi, the min...
based on 1 interview
Interview experience
Inspection Engineer
467
salaries
| ₹1.1 L/yr - ₹8.5 L/yr |
Chemist
328
salaries
| ₹1.1 L/yr - ₹7.2 L/yr |
Executive
211
salaries
| ₹2 L/yr - ₹8.7 L/yr |
Senior Executive
174
salaries
| ₹2.9 L/yr - ₹12.2 L/yr |
Assistant Manager
120
salaries
| ₹6 L/yr - ₹18 L/yr |
Bureau Veritas
Intertek
TÜV SÜD
DNV GL