Rakon Technician Interview Questions and Answers for Freshers

Shutting down a process involves terminating a program or application running on a computer system.

• Use task manager or command line to end the process

• Ensure all unsaved work is saved before shutting down

• Consider any dependencies or impact on other processes

To change motor rotation, swap any two of the three power supply wires.

• Swap any two of the three power supply wires to change motor rotation.

• Ensure power is disconnected before making any changes.

• Consult the motor's manual for specific instructions.

• Test the motor after making the changes to ensure it is rotating in the desired direction.

Two-way connection can be achieved by using two switches to control a single light or appliance from two different locations.

• Install two switches at different locations to control the same light or appliance

• Connect the common terminal of one switch to the phase or live wire

• Connect the common terminal of the other switch to the light or appliance

• Connect the remaining terminals of both switches to complete the circuit

• Tes

Termination for control panel involves connecting wires from various components to the terminal blocks inside the panel.

• Identify the components that need to be connected to the control panel

• Strip the insulation off the wires to expose the conductors

• Connect the wires to the appropriate terminal blocks based on the wiring diagram

• Secure the connections with terminal screws or clamps

• Label the wires for easy identification

Terminating a GIS panel involves connecting and securing the cables to the appropriate terminals.

• Identify the cables to be terminated

• Strip the insulation from the cable ends

• Connect the cables to the designated terminals

• Secure the connections with appropriate fasteners

• Test the connections to ensure they are secure and functioning properly

Termination for switch gear involves connecting the wires to the appropriate terminals for proper functioning.

• Identify the terminals for the switch gear

• Strip the insulation from the wires to expose the conductors

• Connect the wires to the corresponding terminals using appropriate connectors

• Ensure proper tightening of the connectors to secure the connection

• Test the connection to ensure it is functioning correctly