i
Padmini VNA Mechatronics
Filter interviews by
I applied via Naukri.com and was interviewed in Jul 2019. There were 3 interview rounds.
The number of zones in an injection molding machine varies depending on the machine's design and complexity.
The number of zones typically ranges from 2 to 6 in injection molding machines.
Each zone in the machine is responsible for controlling the temperature of a specific section of the mold.
The zones are usually located along the barrel of the machine and can be individually controlled.
The number of zones is determine...
FPA (Function Point Analysis) should be done during the early stages of software development.
FPA helps in estimating the size and complexity of a software project.
It is typically done during the requirements gathering phase.
FPA involves identifying and quantifying the functionality provided by the software.
It helps in determining the effort, cost, and resources required for the project.
FPA can be done using various tec...
Top trending discussions
Assistant Manager
109
salaries
| ₹5.3 L/yr - ₹13 L/yr |
Senior Engineer
75
salaries
| ₹4 L/yr - ₹8.2 L/yr |
Deputy Manager
73
salaries
| ₹8.5 L/yr - ₹18 L/yr |
Engineer
58
salaries
| ₹2.9 L/yr - ₹5.3 L/yr |
Design Engineer
57
salaries
| ₹3 L/yr - ₹5.7 L/yr |
Bharat Forge
Bosch
Mahindra Last Mile Mobility
Tata Motors