Lansum Properties Site Engineer Interview Questions and Answers

Preparing walls for plastering involves several steps in block work.

• Ensure the block work is complete and free of any debris.

• Clean the surface of the walls to remove any dust or dirt.

• Apply a coat of bonding agent to the walls to improve adhesion.

• Allow the bonding agent to dry before applying the plaster.

• Apply the plaster in thin layers, allowing each layer to dry before applying the next.

• Smooth out any imperfections in...read more

Plastering is a process of applying a thin layer of cement mortar over the surface of walls and ceilings.

• Prepare the surface by cleaning and dampening it

• Apply a coat of primer to improve adhesion

• Mix plastering material with water to form a smooth paste

• Apply the first coat of plaster using a trowel

• Allow the first coat to dry and then apply the second coat

• Smooth and level the surface with a float or trowel

• Finish the surf...read more

Design mix refers to the process of selecting suitable proportions of ingredients to create a concrete mix with desired properties.

• Design mix is used in construction to determine the proportions of cement, aggregates, water, and admixtures in a concrete mix.

• It involves testing and adjusting the mix to achieve the desired strength, workability, durability, and other properties.

• Design mix is based on factors such as the ...read more

M25 Concrete is a type of concrete with a compressive strength of 25 megapascals (MPa).

• M25 Concrete is commonly used in construction projects for structural elements like beams, columns, and slabs.

• It is a mix of cement, sand, and coarse aggregates in a ratio of 1:1:2.

• The grade of concrete represents its compressive strength after 28 days of curing.

• M25 Concrete has a moderate strength and is suitable for general constru...read more

Yes, I am familiar with operating theodolite and Auto Level.

• I have experience in using theodolite and Auto Level for surveying and setting out construction sites.

• I am proficient in setting up and calibrating theodolite and Auto Level instruments.

• I can accurately measure angles, distances, and elevations using these instruments.

• I have used theodolite and Auto Level for various projects, including road construction and b...read more

As project head, I would execute the site by overseeing the planning, budgeting, and scheduling of the project.

• Develop a comprehensive project plan that includes timelines, budgets, and resources

• Assign tasks and responsibilities to team members

• Monitor progress and make adjustments as necessary

• Ensure compliance with safety regulations and quality standards

• Communicate regularly with stakeholders to keep them informed of ...read more

Development length is the length of reinforcement required to transfer the stress from steel to concrete.

• It is the minimum length of reinforcement bar required to be embedded in concrete to develop the desired bond strength between steel and concrete.

• It is dependent on the diameter of the bar, the grade of the steel, and the compressive strength of the concrete.

• It is calculated using empirical formulas or tables provid...read more

No, as a Site Engineer, my expertise is in construction and project management, not in manufacturing ammunition.

• As a Site Engineer, my focus is on managing construction projects and ensuring they are completed on time and within budget.

• I do not have any experience or knowledge in the manufacturing of ammunition or BBs.

• My skills and expertise lie in areas such as project planning, site management, and quality control.

The outer diameter of a 12 inch line is approximately 304.8 mm.

• The conversion factor from inches to millimeters is 25.4.

• To convert inches to millimeters, multiply the value by 25.4.

• Therefore, the outer diameter of a 12 inch line is 12 * 25.4 = 304.8 mm.