Filter interviews by
Top trending discussions
An inspection engineer is responsible for ensuring the safety, quality, and compliance of equipment, structures, or systems.
Conducting inspections to identify defects or non-compliance
Developing inspection procedures and protocols
Analyzing inspection data and preparing reports
Collaborating with other engineers and stakeholders
Ensuring compliance with regulations and standards
Implementing corrective actions to address i...
I applied via Referral and was interviewed before Oct 2021. There was 1 interview round.
The 7 QC tools are basic statistical tools used for quality control in manufacturing and other industries.
Check sheets: Used to collect and organize data
Pareto charts: Used to identify the most frequent problems or defects
Histograms: Used to show the distribution of data
Cause-and-effect diagrams: Used to identify the root cause of a problem
Control charts: Used to monitor a process over time
Scatter diagrams: Used to sho...
I applied via Naukri.com and was interviewed in Feb 2021. There were 3 interview rounds.
I applied via Referral and was interviewed in Jul 2021. There were 4 interview rounds.
I applied via Recruitment Consulltant and was interviewed in Dec 2022. There were 3 interview rounds.
Mechanical properties refer to the behavior of materials under applied forces, including strength, hardness, elasticity, and toughness.
Mechanical properties include strength, hardness, elasticity, toughness, ductility, and brittleness.
Strength is the ability of a material to withstand an applied force without failure.
Hardness is the resistance of a material to deformation, scratching, or abrasion.
Elasticity is the abil...
Testing processes are essential for ensuring the quality and safety of products or systems.
Testing processes involve conducting various tests to evaluate the performance, reliability, and safety of products or systems.
Types of testing processes include non-destructive testing, destructive testing, visual inspection, and dimensional inspection.
Testing processes help identify defects, weaknesses, or areas for improvement...
PSSR stands for Pre-Startup Safety Review. It is a systematic review of safety aspects before starting up a new or modified process.
Ensures that all safety systems are in place and functioning properly before starting operations
Identifies potential hazards and risks that may arise during startup
Helps in preventing accidents and ensuring the safety of personnel and equipment
Commonly used in industries such as oil and ga...
RT and UT are non-destructive testing methods used in inspection to detect flaws in materials.
RT stands for Radiographic Testing, which uses X-rays or gamma rays to inspect the internal structure of materials.
UT stands for Ultrasonic Testing, which uses high frequency sound waves to detect flaws or measure thickness in materials.
RT is commonly used for detecting internal defects in welds, castings, and forgings.
UT is o...
I appeared for an interview in Feb 2025, where I was asked the following questions.
based on 20 reviews
Rating in categories
Inspection Engineer
121
salaries
| ₹2.2 L/yr - ₹6.9 L/yr |
Third Party Inspection Engineer
43
salaries
| ₹1.8 L/yr - ₹6.7 L/yr |
Dy. Surveyor
38
salaries
| ₹2.4 L/yr - ₹5.8 L/yr |
Surveyor
30
salaries
| ₹2.5 L/yr - ₹5.4 L/yr |
Third Party Inspector
25
salaries
| ₹2 L/yr - ₹7.2 L/yr |
Bureau Veritas
SGS
CMS Infosystems
Intertek