INDO-MIM Process Engineer Interview Questions and Answers

It was fundamental and basic

Q1. This was a one o one interview with the Hr and selected people will move to the other 2 technical rounds
Add your answer
Q2. Can you introduce yourself and provide an overview of the projects you have worked on?
Ans. 
I am a recent graduate with experience in project management and engineering design.
• Managed a team of 5 to design and implement a solar-powered irrigation system for a local community

• Developed a prototype for a new sustainable packaging material using biodegradable materials

• Collaborated with a cross-functional team to optimize production processes and reduce waste in a manufacturing plant
Answered by AI
Add your answer

Q1. Questions were asked regarding suspension geometries and calculations?
Add your answer
Q2. Explain about the different suspension geometries and explain how forces act on them
Ans. 
Suspension geometries include double wishbone, MacPherson strut, and multi-link, each experiencing different forces like compression, rebound, and lateral forces.
• Double wishbone suspension has two control arms that allow for independent control of camber and toe angles.

• MacPherson strut suspension uses a single control arm and a strut to support the wheel and handle vertical forces.

• Multi-link suspension uses multiple co...read more
Answered by AI
Add your answer

Q1. What does the stress-strain graph of stainless steel look like?
Ans. 
Stress-strain graph of stainless steel typically shows a linear elastic region followed by a yield point and then strain hardening.
• Stainless steel initially deforms elastically until reaching the yield point

• After the yield point, plastic deformation occurs with strain hardening

• The graph may show a slight decrease in stress before reaching ultimate tensile strength

• Fracture occurs after the ultimate tensile strength is r
Answered by AI
Add your answer

Q1. Difference between latch and flip flop
Ans. 
Latch is level triggered, while flip flop is edge triggered. Latch is asynchronous, while flip flop is synchronous.
• Latch is level triggered, meaning it changes output based on the input level. Flip flop is edge triggered, meaning it changes output based on the edge of the clock signal.

• Latch is asynchronous, meaning it can change output at any time. Flip flop is synchronous, meaning it changes output only at specific ti...read more
Answered by AI
Add your answer
Q2. What is amplitude modulation
Ans. 
Amplitude modulation is a method used in electronic communication to encode information on a carrier wave by varying the amplitude of the wave.
• Amplitude modulation involves varying the amplitude of a high-frequency carrier wave in proportion to the waveform being transmitted.

• The modulating signal is the signal that contains the information to be transmitted.

• The carrier wave is the high-frequency signal that is modulate...read more
Answered by AI
Add your answer

Q1. Tell me about yourself
Add your answer

Electronics and ice engine

Q1. About technical questions
Add your answer

Q1. What are your salary expectations?
Add your answer
Q2. Any questions hr team
Ans. My contact no not any time network area ple msg me
Answered Anonymously
View 4 more answers

Diploma

Q1. What are your salary expectations?
Add your answer

Q1. Depends on experience
Add your answer
Q2. Related to systematic approach
Ans. Problem solving tools, OEE, FPY, Root cause analysis. 14Q, 5S
Answered Anonymously
Add your answer