Filter interviews by
I appeared for an interview before Feb 2018.
Top trending discussions
There are typically three types of offset in CNC: tool length, cutter radius, and workpiece origin.
Tool length offset compensates for the length of the tool.
Cutter radius offset compensates for the radius of the cutting tool.
Workpiece origin offset sets the origin point for the CNC machine to begin cutting.
Other types of offset may include fixture offsets and wear offsets.
To enter offset 15micron in dia less, use the G10 command and specify the offset value.
Use the G10 command to enter the offset value
Specify the offset value as 15micron in dia less
Make sure to save the offset value using the G54-G59 commands
Verify the offset value using the G54.1-G59.3 commands
I applied via Referral and was interviewed in Jun 2021. There were 3 interview rounds.
I applied via Walk-in and was interviewed in Jul 2022. There were 2 interview rounds.
I have work experiance of quality department inspection experiance and inprocess experiance and leading team experiance
Quality is the degree of excellence of a product or service that meets or exceeds customer expectations.
Quality is a measure of how well a product or service meets customer needs and expectations.
It involves meeting or exceeding customer requirements and standards.
Quality can be achieved through continuous improvement and adherence to established processes and standards.
Quality inspection is the process of checking pro...
I applied via Referral and was interviewed before Jun 2020. There was 1 interview round.
I applied via Recruitment Consulltant and was interviewed in Jun 2022. There were 4 interview rounds.
Question abou TPM, OEE, six Sigma, lean manufacturing,kaizen,poka yoke etc
I applied via Walk-in and was interviewed in Jun 2021. There were 5 interview rounds.
I applied via Naukri.com and was interviewed in Aug 2023. There were 4 interview rounds.
Core tools of AIAG include FMEA, PPAP, MSA, SPC, and APQP.
FMEA (Failure Mode and Effects Analysis) is used to identify and prioritize potential failure modes in a process.
PPAP (Production Part Approval Process) is used to ensure that suppliers meet customer requirements.
MSA (Measurement Systems Analysis) is used to assess the quality of measurement systems.
SPC (Statistical Process Control) is used to monitor and contro...
I have experienced failures in project deadlines, communication, and technical solutions.
Missed project deadlines due to underestimating tasks
Miscommunication with team members leading to misunderstandings
Implemented technical solutions that did not meet requirements
Heat treatment process is a method used to alter the physical and sometimes chemical properties of a material through heating and cooling.
Involves heating the material to a specific temperature
Holding it at that temperature for a set amount of time
Then cooling it at a controlled rate
Can be used to increase hardness, improve machinability, or enhance other properties
Common techniques include annealing, quenching, temper
I appeared for an interview in Apr 2023.
I applied via LinkedIn and was interviewed in Dec 2021. There were 2 interview rounds.
Reasoning questions general aptitude English speaking
Quality Engineer
61
salaries
| ₹1.6 L/yr - ₹4.3 L/yr |
Engineer
23
salaries
| ₹1.1 L/yr - ₹5 L/yr |
Senior Engineer
22
salaries
| ₹4 L/yr - ₹8.5 L/yr |
Assistant Manager
19
salaries
| ₹5.5 L/yr - ₹11.6 L/yr |
Production Engineer
19
salaries
| ₹1.6 L/yr - ₹4.6 L/yr |
ZF Steering Gear
Ag Industries
Toyoda Gosei Minda
Global Autotech