Global Hydro Engineers Mechanical Engineer Interview Questions, Process, and Tips

The zero point of a turbine refers to the point at which the turbine is not generating any power or producing any rotational motion.

• The zero point of a turbine is when the rotational speed is zero.

• At the zero point, the turbine blades are not moving and there is no power output.

• The zero point is important for maintenance and troubleshooting purposes.

• For example, if a turbine is not starting or producing power, checking...read more

Throw and gradient can be calculated using specific formulas and measurements.

• Throw is the horizontal distance between the point of projection and the point of landing.

• Gradient is the vertical change in elevation over a given horizontal distance.

• To calculate throw, you need to measure the initial velocity, angle of projection, and gravitational acceleration.

• To calculate gradient, you need to measure the change in eleva

An air gap is a physical space between two objects or surfaces, often used to prevent the transfer of heat or electricity.

• An air gap is commonly used in electrical systems to prevent electrical current from flowing between conductive materials.

• In plumbing systems, an air gap is used to prevent backflow of contaminated water into the main water supply.

• Air gaps are also used in insulation to prevent heat transfer between...read more

The magnetic axis is an imaginary line that represents the direction of the magnetic field in a magnetic object.

• The magnetic axis is calculated by determining the average direction of the magnetic field in the object.

• It is often determined using magnetic sensors or compasses.

• The magnetic axis is important in understanding the behavior and properties of magnetic materials.

• It helps in designing and analyzing magnetic dev...read more

To find the unit center, calculate the average of all the unit positions.

• Calculate the x-coordinate of the unit center by averaging the x-coordinates of all the units.

• Calculate the y-coordinate of the unit center by averaging the y-coordinates of all the units.

• If the units are represented by points in a 2D plane, the unit center can be found by taking the average of the coordinates.

• For example, if there are three units...read more

The type of oil used in LGP, UGP, and OPU depends on the specific application and requirements.

• LGP, which stands for Liquefied Petroleum Gas, typically uses propane or butane as the oil.

• UGP, which stands for Underground Gas Pipeline, may use a variety of oils depending on the specific gas being transported.

• OPU, which stands for Oil Pumping Unit, uses lubricating oil to ensure smooth operation of the pump.

• The specific t...read more