Genus Power Infrastructures Quality Analyst Interview Questions and Answers

Q1. Basic knowledge of role based on experience level
Add your answer

100 marks paper in that cut will depend on no. Of person attempting

There will be a topic .., in that you have to give u r best

Q1. Related u r previous experience if any , some technical question
Ans. Be prepared for this .. important
Answered Anonymously
Add your answer

Q1. Regarding salary packages etc
Ans. Demand high salary other than u r expecting
Answered Anonymously
Add your answer

Q1. What is mix design?
Ans. 
Mix design is the process of determining the proportions of ingredients to create a concrete mix with desired properties.
• Mix design involves selecting the appropriate materials such as cement, aggregates, and water.

• The proportions of each material are determined based on the desired strength, workability, and durability of the concrete mix.

• Testing is often conducted to ensure the mix meets specified requirements before
Answered by AI
Add your answer

It was simple as well as difficult

Q1. Personal information previous job experience
Add your answer

Q1. During interview asking technical questions regarding to my job profile
Add your answer
Q2. During interview asking questions related GIS substation electrical equipment and it's testing & working criteria with acceptance range & inspection point to be noted as per quality requirement
Ans. As per TS and SFQP work will done
Answered by Amit Shukla
Add your answer

Q1. Please provide all the required sizes of sieves needed to establish a fine aggregate sieve analysis.
Ans. 
The required sizes of sieves for fine aggregate sieve analysis are typically 3/8", #4, #8, #16, #30, #50, #100, and pan.
• 3/8" sieve

• #4 sieve

• #8 sieve

• #16 sieve

• #30 sieve

• #50 sieve

• #100 sieve

• Pan
Answered by AI
Add your answer
Q2. What is characteristic strength and terget mean strength ? Relation between both ?
Ans. 
Characteristic strength is the strength of a material below which not more than a specified proportion of test results are expected to fall. Target mean strength is the strength that a structure is designed to achieve.
• Characteristic strength is a statistical value representing the lower tail of the strength distribution of a material.

• Target mean strength is the strength that a structure is designed to achieve based on ...read more
Answered by AI
Add your answer
Q3. Explain M25 and what should be the value of cube of M25 grade concrete ?
Ans. 
M25 is a mix of concrete with a compressive strength of 25 MPa. The cube strength of M25 grade concrete should be 25 MPa.
• M25 is a mix of concrete with a compressive strength of 25 MPa.

• The cube strength of M25 grade concrete should be 25 MPa.

• The mix proportion for M25 grade concrete is usually 1:1:2 (cement:sand:aggregate).
Answered by AI
Add your answer
Q4. Difference between OPC and PPC cement ?
Ans. 
OPC cement is Ordinary Portland Cement, while PPC cement is Portland Pozzolana Cement.
• OPC is made by grinding clinker with gypsum, while PPC is made by intergrinding clinker with fly ash and gypsum.

• PPC has higher long-term strength and durability compared to OPC.

• PPC is more environmentally friendly due to the use of fly ash as a partial replacement for clinker.

• OPC is commonly used for general construction purposes, whi...read more
Answered by AI
Add your answer

Q1. Salary expectation and place of posting
Add your answer
Q2. Discussion about adjust notice period
Add your answer
Q3. Family background and future planning
Add your answer