Filter interviews by
Top trending discussions
I appeared for an interview in Oct 2017.
A transformer is an electrical device that transfers electrical energy from one circuit to another through electromagnetic induction.
Transformers are used to increase or decrease the voltage of an alternating current (AC) power supply.
They consist of two coils of wire, called the primary and secondary coils, wrapped around a magnetic core.
When an AC current flows through the primary coil, it creates a magnetic field th...
Ohm's law states that the current through a conductor between two points is directly proportional to the voltage across the two points.
Ohm's law is represented by the equation V = IR, where V is voltage, I is current, and R is resistance.
The power formula is P = VI, where P is power, V is voltage, and I is current.
Ohm's law is used to calculate the resistance of a circuit and to determine the amount of current flowing ...
Initial setting time of cement is the time taken by cement to harden and resist penetration by a standard needle.
Initial setting time is affected by factors like temperature, water-cement ratio, and type of cement.
The standard needle used for testing has a diameter of 1.13 mm and a length of 50 mm.
The initial setting time of ordinary Portland cement is around 30 minutes.
The initial setting time of rapid hardening cemen
Lime test stone test brick test
Basic Study
I applied via Campus Placement and was interviewed in Feb 2022. There were 2 interview rounds.
Technical knowledge and aptitude test after interview
Know me about your technical knowledge and your skill
Questions related to electrical engineering concepts such as transformers, AC and DC, motor, electromagnetic induction law, and Ohm's law.
Transformers are devices that transfer electrical energy from one circuit to another through electromagnetic induction.
AC (alternating current) changes direction periodically while DC (direct current) flows in one direction only.
A motor is a device that converts electrical energy int...
Questions related to generators, power transmission, and thermocouples.
Types of generators include diesel, gas, wind, and hydroelectric.
India's generation capacity is around 370 GW.
Maximum power transmission in India is around 1,050 GW.
Transmission of maximum power is important to ensure efficient and reliable power supply.
A thermocouple is a device used to measure temperature and is commonly used in industrial applica
I appeared for an interview in Feb 2025.
Wind power generation converts wind energy into electricity using turbines, harnessing natural wind flow for sustainable energy.
Wind turbines capture kinetic energy from wind.
The rotor blades spin, turning a shaft connected to a generator.
The generator converts mechanical energy into electrical energy.
Electricity is transmitted through power lines to homes and businesses.
Example: Offshore wind farms utilize strong sea
The supply process in a grid system involves generation, transmission, distribution, and consumption of electrical energy.
1. Generation: Electricity is generated at power plants using various sources like coal, natural gas, nuclear, or renewables (e.g., solar, wind).
2. Transmission: High-voltage transmission lines carry electricity over long distances to minimize energy loss.
3. Substations: Voltage is reduced at substa...
Quality Engineer
324
salaries
| ₹1.1 L/yr - ₹4.2 L/yr |
Production Engineer
184
salaries
| ₹0.9 L/yr - ₹6 L/yr |
Production Supervisor
96
salaries
| ₹1 L/yr - ₹4.6 L/yr |
Graduate Engineer Trainee (Get)
90
salaries
| ₹1 L/yr - ₹3 L/yr |
Design Engineer
87
salaries
| ₹1.5 L/yr - ₹5.5 L/yr |
Vestas
Wind World
Siemens Energy
Steag Energy Services