i
L&T Defence
Filter interviews by
Clear (1)
I was interviewed before Dec 2022.
Top trending discussions
I applied via Walk-in and was interviewed in Jan 2020. There were 5 interview rounds.
posted on 15 Mar 2024
posted on 19 Oct 2023
I applied via Company Website and was interviewed in Sep 2023. There was 1 interview round.
I applied via Company Website and was interviewed in Jan 2023. There were 3 interview rounds.
Factor of safety is a design parameter that accounts for uncertainties in material properties and loading conditions.
Factor of safety is the ratio of the maximum stress a material can withstand to the maximum stress it is subjected to in a given application.
It ensures that the structure or component will not fail under normal operating conditions.
Higher factor of safety values indicate a more conservative design approa...
Tolerance refers to the allowable variation in dimensions or properties of a part or product.
Tolerance is important in engineering to ensure proper fit and function of components.
It is typically specified as a range of acceptable values, such as +/- 0.1mm.
Tolerance can be applied to dimensions, material properties, surface finish, etc.
For example, a hole may have a tolerance of +/- 0.05mm to allow for proper alignment
Baud rate is the rate at which data is transmitted over a communication channel.
Baud rate is measured in bits per second (bps).
Higher baud rates allow for faster data transmission.
Baud rate must be set the same on both ends of the communication channel.
Incorrect baud rate settings can result in data corruption or loss.
Examples of communication channels that use baud rate include UART, SPI, and I2C.
I2C is a serial communication protocol used to connect multiple devices with two wires. Pull-up resistors are necessary for proper communication.
I2C uses a master-slave architecture where the master initiates communication.
Each device on the bus has a unique address assigned to it.
Data is transmitted in packets with a start and stop bit.
Pull-up resistors are necessary to ensure proper voltage levels on the bus.
The valu...
posted on 29 Mar 2023
I applied via Campus Placement and was interviewed before Mar 2022. There were 3 interview rounds.
posted on 18 May 2024
posted on 28 May 2022
I applied via Company Website and was interviewed in Nov 2021. There was 1 interview round.
based on 1 interview
Interview experience
based on 1 review
Rating in categories
Assistant Manager
105
salaries
| ₹0 L/yr - ₹0 L/yr |
Design Engineer
77
salaries
| ₹0 L/yr - ₹0 L/yr |
Senior Engineer
72
salaries
| ₹0 L/yr - ₹0 L/yr |
Junior Engineer
54
salaries
| ₹0 L/yr - ₹0 L/yr |
Junior Supervisor
45
salaries
| ₹0 L/yr - ₹0 L/yr |
Bharat Electronics
Hindustan Aeronautics
Tata Advanced Systems
Mahindra Defence Systems