Hercules Hoists Service Engineer Interview Questions and Answers

Q1. What is Your rolls and responsibility in current organization?
Add your answer
Q2. Why you want to change company?
Add your answer

Q1. Types and welding, in which material you have knowledge about?
Ans. 
I have knowledge of various types of welding in materials such as steel, aluminum, and titanium.
• I have experience with MIG, TIG, and stick welding techniques.

• I am familiar with welding codes and standards such as AWS D1.1 and ASME Section IX.

• I have worked with various thicknesses of materials ranging from thin sheet metal to heavy plate.

• Examples of projects I have worked on include welding structural steel for building...read more
Answered by AI
Add your answer
Q2. What is permissible offset in shell to dish end setup?, types of weld joint, categories of weld joint etc.
Ans. 
Permissible offset in shell to dish end setup, types and categories of weld joint.
• Permissible offset in shell to dish end setup is typically 1/16 inch.

• Types of weld joint include butt joint, lap joint, corner joint, and T-joint.

• Categories of weld joint include groove weld, fillet weld, plug weld, and slot weld.
Answered by AI
Add your answer
Q3. What is welding?, have you knowledge about TPM, FUNGAI TREE, 5'S, SIX SIGMA, etc.
Ans. 
Welding is a process of joining two or more metal parts by heating the surfaces to their melting points and applying pressure.
• TPM stands for Total Productive Maintenance and is a system for maximizing equipment effectiveness.

• Fungai tree is not a known term in engineering.

• 5S is a methodology for workplace organization and standardization.

• Six Sigma is a data-driven approach for process improvement.
Answered by AI
Add your answer

Q1. Baasic mechanical calculations
Add your answer
Q2. About G&T and basic calculations
Add your answer

Q1. Hydraulic, Electrical and circuit
Add your answer

Q1. Introduction and Family background
Add your answer

Basic aptitude test regarding quantitative, mathematical & English

Q1. Basic theory of newton
Add your answer

Q1. Motor,transformer, Generator & Relay related questions
Add your answer

Q1. Salary related & other
Add your answer

Q1. About the current role and responsibilities
Add your answer
Q2. Current CTC and expected CTC
Ans. 
Current CTC is confidential. Expectation is based on industry standards and job responsibilities.
• Current CTC is confidential information and should not be disclosed in an interview.

• Expected CTC is usually based on industry standards, job responsibilities, and the candidate's experience.

• It is important to research the average salary range for the position and negotiate accordingly.
Answered by AI
Add your answer

Q1. What is the method for calculating the circumference of a circle using a measuring tape?
Ans. 
To calculate the circumference of a circle, measure its diameter with a tape and multiply by π (pi).
• Use a flexible measuring tape to measure the diameter of the circle directly across its center.

• Ensure the tape is straight and not sagging for an accurate measurement.

• Once you have the diameter (d), use the formula: Circumference (C) = π × d.

• For example, if the diameter is 10 cm, then C = π × 10 cm ≈ 31.42 cm.

• Alternative...read more
Answered by AI
Add your answer
Q2. What is the conversion factor from inches to millimeters?
Ans. 
1 inch is equal to 25.4 millimeters, a standard conversion used in engineering and design.
• 1 inch = 25.4 mm

• To convert inches to mm, multiply the number of inches by 25.4.

• Example: 2 inches = 2 * 25.4 = 50.8 mm

• Example: 5 inches = 5 * 25.4 = 127 mm

• This conversion is crucial for precision in mechanical design.
Answered by AI
Add your answer